08-10-2023 09:55 AM
can sg200-26p pass through dhcp services when in static mode
08-10-2023 10:03 AM
Hi @lespoehner
This switch does not support to be DHCP server but it does support to be DHCP client.
Other management |
HTTP, RADIUS, port mirroring, TFTP upgrade, DHCP client, BOOTP, SNTP, ping, syslog
|
08-15-2023 03:30 AM
in adition to above,
within a single vlan the switch will process (forward) DHCP packets just like any trafic
if that is what you mean with "pass through dhcp services" ?
08-15-2023 01:39 PM
08-15-2023 11:23 PM - edited 08-15-2023 11:26 PM
Hi there,
so to hear you are al ready quite advancing in your network
if the SG200 only processes VLAN's and the UDP PRO is properly configured for vlans and DHCP then you should be OK
this static setting will mean you assign the SG200 a static (fixed) IP-address instead of the SG200 requesting a dynamic address from the UDP PRO pool
so check the SG200 has DHCP server disabled, this is another setting than setting the IP-addres as static
Dynamic Host Configuration Protocol (DHCP) Server Auto Configuration on the 200/300 Series Managed Switches - Cisco
found this post: Solved: SG200-26 DHCP-Feature not working? - Cisco Community
The 200 series of switches does not have being a DHCP server as a feature. The 300s and higher have DHCP server as an option on them, but the 200 does not since it is just a layer 2 switch.
08-16-2023 07:07 AM
“I am wanting DHCP services for the devices connected to the SG200 to come from the UDM PRO for straightforward management.”
If that does not work with your VLANs, there must be some mismatch in the VLAN configuration between the SG200 and the Ubiquity side. The configuration of the switch’s IP address does not play any role in it.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide