cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3094
Views
0
Helpful
3
Replies

snmp oids for the command "show counters interface intx/y delta"

ROMAN TOMASEK
Beginner
Beginner

Hello,

I have a question about SNMP OIDs for the command "show counters interface intx/y delta" on Catalyst6500. The customer wants to create graphs for the following values:Overruns, qos0Outlost, InErrors, OutErrors, InDiscards, OutDiscards etc..

Is possible to get these values using SNMP??

Thank you

Roman

3 Replies 3

Dan Frey
Cisco Employee
Cisco Employee

These OIDs can be found in the IF-MIB located here:

ftp://ftp-sj.cisco.com/pub/mibs/oid/IF-MIB.oid

Regards,

Dan

Thank you, Dan. These OIDs are for the output from the command "show interface int x/y". But I think, that these OIDs are not for the command "show interface int x/y delta".

Roman

I am very interested in this also... especially the qos0Outlost value!

John

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers