Syslog interface Up/down

[jorge.s]

I'm collecting the Syslog messages with Ciscoworks, but on Severity Level 3 I'm receiving lots of messages regarding interface up/down which I don't care.

Is there a way to disable that ? without disable all severity level 3? since there are other messages important? And can we configure which ports should log that messages? I care about server's port's or important port's, but not all users...

Thanks for your help!

Jorge Sousa

[nhabib]

In IOS, for each interface you may configure:

no logging event link-status

[jorge.s]

is there any command to apply on all ports by default?

[nhabib]

Unfortunately not.

[RouterTech1]

You could try redefining the syslog message to a lower level.

Take the syslog number that you're getting, and enter a command on your pix that goes like this:

logging message 109012 level warning

replace 109012 with the link up/down specific number

hmm.. consider that you do want some but not all, the other alternative is to filter the device description for those specific ports, perhaps.