cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1121
Views
0
Helpful
5
Replies
Highlighted
Not applicable

Using a Meraki switch with Cisco CER

Is it possible to use Cisco  Meraki switches to work in Cisco CER.

From looking at CER documentation it seems that Catalyst switches are required.
However, we were encouraged to purchase Meraki switches and now cannot get them
working in our CER enviorment.

5 REPLIES 5
Highlighted
Advisor

Highly unlikely to be compatible.

Highlighted

Please check out this URL:

https://documentation.meraki.com/MS/Deployment_Guides/Cisco_Emergency_Responder_Integration

 

Thanks,

Vaijanath Sonvane

Please rate helpful posts and if applicable mark "Accept as a Solution".
Thanks, Vaijanath S.
Highlighted

I can confirm the Meraki MS225 and MS410 switches do work.  But the MS120's are not fully reporting their switch ports.

Anybody know why?

Highlighted

Krisko-
As per the Cisco Emergency Responder documentation, the Meraki MS120 switches are not supported. Only the below are supported:

Meraki MS210
Meraki MS225
Meraki MS250
Meraki MS320
Meraki MS350
Highlighted
Beginner

This is absolutely possible!   The following Cisco Meraki switches are supported on Cisco Emergency Responder 12.5(1) as of January 17, 2020, found in the Cisco Emergency Responder Version 12.5(1) Release Notes

 

The deployment guide is over on the Meraki website, in case anyone is looking.  It can be found here, Cisco Emergency Responder Integration

 

Meraki MS210
Meraki MS225

Meraki MS250 

Meraki MS320

Meraki MS350

 

Regards,

 

Dalton Woolsey

Content for Community-Ad