cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
6770
Views
16
Helpful
3
Replies

ASAv channel-group command not available under interface

networkwise
Level 1
Level 1

Hi,

I have an ASAv Firewall. My goal is to combine a couple of interfaces into a logical port channel.

When I enter config mode and go into an interface the channel-group command is not there.

Wondering what I'm not doing, besides not being smart ?

 

Andy

 

ASA1(config-if)# ?                      
 
Interface configuration commands:
  authentication   authentication subcommands
  bfd              BFD interface configuration commands
  bridge-group     Specify the bridge group that this interface is a part of
  cts              Configure interface specific CTS settings
  ddns             Configure dynamic DNS
  default          Set a command to its defaults
  delay            Specify interface throughput delay
  description      Interface specific description
  dhcp             Configure parameters for DHCP client
  dhcprelay        Configure DHCP Relay Agent
  duplex           Configure duplex operation
  exit             Exit from interface configuration mode
  flowcontrol      Configure flowcontrol operation
  hello-interval   Configures EIGRP-IPv4 hello interval
  help             Description of the interactive help system
  help             Interactive help for interface subcommands
  hold-time        Configures EIGRP-IPv4 hold time
  igmp             IGMP interface commands
  ip               Configure the ip address
  ipv6             IPv6 interface subcommands
  mac-address      Assign MAC address to interface
  management-only  Dedicate an interface to management. Block thru traffic
  mfib             Interface Specific MFIB Control
  multicast        Configure multicast routing
  nameif           Assign name to interface
  no               Negate a command or set its defaults
  nve-only         Dedicate an interface to source-interface of a NVE. Block
                   thru traffic
  ospf             OSPF interface commands
  pim              PIM interface commands
  policy-route     Enable policy based routing
  pppoe            Configure parameters for PPPoE client
  rip              Router Information Protocol
  security-level   Specify the security level of this interface after this
                   keyword, Eg: 0, 100 etc. The relative security level between
                   two interfaces determines the way the Adaptive Security
                   Algorithm is applied. A lower security_level interface is
                   outside relative to a higher level interface and equivalent
                   interfaces are outside to each other
  shutdown         Shutdown the selected interface
  speed            Configure speed operation
  split-horizon    Configures EIGRP-IPv4 split-horizon
  summary-address  Configures EIGRP-IPv4 summary-address
  zone-member      Associate interface to a zone
1 Accepted Solution

Accepted Solutions

The ASAv does not support Ether-Channels. You also should ask yourself for what it should be used? You would combine two virtual interfaces to a new virtual interface. You don't get any real benefit from that. If you want redundancy for your outside links, just build the channels on the hypervisor-host.

View solution in original post

3 Replies 3

The ASAv does not support Ether-Channels. You also should ask yourself for what it should be used? You would combine two virtual interfaces to a new virtual interface. You don't get any real benefit from that. If you want redundancy for your outside links, just build the channels on the hypervisor-host.

Thanks for your guidance. I'm using the ASAv in a GNS environment, I'd set up a lab and wanted to configure EtherChannel between the Firewall and a IOSv switch. Your comments makes sense.


Thanks for the support.

 

Andy 

Hello,

 

A use case : ASAv to 2 vPC nexus

 

Regards

Review Cisco Networking for a $25 gift card