Resolved! Convert FTD to ASA OS (FPR4140)
I have a FPR4140, it is running FTD, now I want to transfer it to the ASA OS.Can anyone please give me material to do this.Thanks very much.
Forum Posts
Hi, I have an ASA I have inherited and I am having trouble getting a new DMZ interface to work as expected. I have setup the basic interface (IP, security level etc) and from ARP i can see a client connected to it which is what I expect. I cannot how...
Hello, Could you please able to advise as Meltdown and Spectre vulnerabilities affected to Sourcefire? If affected, please kindly advise any fix for these vulnerabilities Thanks,
Resolved! FTD initial configuration & management
Seems like this should be a simple thing, but I'm stuck. I have FTD installed, but the network settings I gave during the install process did not "take" and I do not see a way to configure the interfaces with IP addresses from looking through the doc...
I didn’t see anything for time based ACL in my rule. Am I missing something? Also it appears my FTD device managed by FMC is using UTC time, is this normal? I have a case open with TAC but we can’t seem to change it to CST.
I recently took an update to Java and am now at Java 8. When I click on my ASDM icons, it says I have a missing javews.exe file and will not open. When I try to run ASDM as a local application, it is asking for a username and password which none of t...
Hello all, I am hoping someone else has seen this issue, and can provide some insight. We performed the above mentioned upgrade and have since lost icmp traffic from our DMZ to the outside. All icmp traffic passes fine from the inside->outside, or...
Good day, Trying to recover a ASA 5505. Not sure of the history but its saying FILE NOT FOUND and going to ROMMON MODE. ASA OUTPUT Cisco Security Appliance admin loader (3.0) #0: Tue Jul 14 22:20:02 PDT 2015Platform ASA5505 Loading...IO memory...
Hello Was trying to find some general practice/ threat detection (and response) to any incoming attacks. I seem to find quite a bit of information but not too many geared towards my 891. Would this fall under Threat Detection or would I build a Fi...
Hello Experts, I have recently purchased few ASA Firepower 5545. I wanted to register my PAK, thus needed to access my ASA > ASDM> configuration> ASA Firepower Configuration option " to findout the license-key. but when I go to ASDM>Configur...
Is it possible to create Intelligent Application Bypass rules that leverage custom application detectors? Is it possible to leverage access policy rules with custom application detectors? When I attempt to do so, they do not show as available appli...
hi, due to the recent SSL VPN vulnerability on the ASA, i need to perform an emergency upgrade. https://tools.cisco.com/security/center/content/CiscoSecurityAdvisory/cisco-sa-20180129-asa1 i got 5525-X on 9.4(4)5 code with FP module (6.0 image). th...
I am trying to figure out how to exempt all (or even specific) internal traffic from a pre-processor rule (HI_CLIENT_OVERSIZE_DIR (119:15:2)) in FP 6.22. Suggestions?
Resolved! Pix-515E IOS
Good morning,I was wondering if I picked up a used (End of Life) pix-515e, would would I need to do to be able to upgrade it to that latest version of IOS made for that product? Is it still possible to even get access to that version? Will cisco al...
Hi, Just want to ask why there is no anyconenct image on the flash on our new ASA. May I jknow if this is normal? Should i download it manually and upload it to the ASA? Thank you Rojhon
