Network Security

I'm hoping someone can please help me out.  I  have an ASA 5510 connected to a 3560 PoE Switch and the switch has a Digium D40 IP Phone connected to it.  I have an IP address of 10.10.10.1 /24 on the Ethernet 0/2 where the switch is connected. The ...

Will it cause issues if the burned in mac addresses are used as the virtual mac addresses when configuring failover on an ASA? Or will the cause issues in the case where the secondary comes up first and assumes the active state using the mac addresse...

If a sub interface is added to a currently in-use interface on an ASA 5510, will this bring the interface down? The situation is that all 4 of the ports on our production ASA 5510 are currently in use.  The overall aim is to add a test DMZ but there ...

Dear Support; I have 2 Cisco ASA 5520 running 8.3 version The two asa are connected back to back. I want to allow internal netwrok behind asa 2 to access Internet Throught ASA 1. I want to also allow somme remote sites directellly connected to ASA ...

Hi Expert i have one asa 5512x with firepower managed by firepower management center and i have L-ASA5512-TA SEULA . but there is no PAK with that . FMS show me Protection license is required when i add access control policy on this ASA 5512 .  How ...

HI Experts, I have a NAT policy that I need to migrate from ASA 72.2(4) to ASA 9.2(2)4 My current NAT policy is on 7.2 code is sh run access-list policy_nat_1 access-list policy_nat_1 extended permit ip host priv-ip object-group obj-group static (ins...

Can somebody please help on the commands to configure console (ilo) IP on Firepower sensor with OS 5.4 version?