Network Security

Hi All, I have a below doubt on my setup. I am not sure whether setup i have built is as per IDS standards or not but SNORT IDS is not capturing traffic. I want to be sure from switch end i have mapped the needs of IDS. Below is the setup i have buil...

Can I configure block or approve the url traffic in this way in a FMC? For example: *.gob *.edu *.gob.co Regards

Just trying to run a packet tracer on my Firepower device, and I do get output when I use the "diagnostic" interface.  However, if I try to use any of the actual interfaces, I get the following error: "An error occured while executing the Packet Trac...

Hello  I'm looking to order firewall with IPS/IDS support to integrate main site( 70 users ) with 10 branches (15 users/ site), any recommend model, i think  the ASA 5500-x is EoS and cisco advice to migrate to firepower appliance. thanks for help

Hello, What is the Management Interface on an ASA 5510 / 5520 meant to be used for...? I am not a firewall boffin by any means but recently I've had to set up both 5510 and 5520 ASA's, part of the set up was to use the management interface for the sy...

I can't connect via ASDM 7.5(2) 153 to newly installed ASA 9.4(2)11.   I can connect via https://host_ip/admin/exec/ sh ver or do any other command.   I also get unable to connect to via ASDM with Java Web Start to run too?  Running Java 8r111.    I ...

Has anyone had any luck in getting this working? I downloaded and installed on Win 7 64bit and after launching found myself not able to configure the agent due to not being able to navigate within the front end . I tried maximizing the window etc but...

Hi, I have to migrate ASA5510 to ASA5545x. This is a management firewall and takes care of hell lot of management traffic. So my concern here is when I shut down the old ASA5510 and bring in the new ASA5545x, the MAC addresses are going to be changed...

Is it possible to determine users that connect to my services by proxy, vpn tunnels or TOR? I know that IS can block by tor_exit_node, but I need only to determine. Also I see that SFR can to determine applications like proxy and vpn, but it's not cl...

Hey, Is there a best practice when there is the need to change Interfaces on ASA 5520? I have configured "External" and "Internal" Interface on let's say Gi0/0 and Gi0/1. Now I upgraded my ASA with 4GE-SSM RJ45 module. I need to switch the "Externa...

Hi Team,  We are planning to deploy the security intelligence feeds into the firewall policy. But is there a way we can see the list of IP's in the list to ensure benign IP's are not being blocked. Is there a way we can export the SI feeds into a CS...