Hi all Does anyone know how to go about getting BFD offloaded in hardware on the Cat9500 platform?More specifically we're talking about the C9500-24Q device. We're currently using BFD, but everything is handled in software as per the output of the "s...
Hi I'm trying to convert a 9336C-FX2 switch from ACI software to NX-OS v9.3.5 and I'm following this guide:https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus9000/sw/93x/upgrade/guide/b-cisco-nexus-9000-nx-os-software-upgrade-downgrade-gu...
Hi all
Currently our backups are failing on our CSM v4.7 installation. We get this error:
Backup failed on 2015/02/11 at 03:23:14. REASON: Fatal error: Database engine 'csmEng' could not be started on database 'vms' in Bulk mode..
Do you guys h...
HiI'm trying to upgrade our CSM from version 4.4-SP2 to v4.5, however the setup complaints that dbeng10.exe is still running, however there is no service to stop this process. Can I just kill it the hard way or is there a better way to do it? I don't...
Hi allI've got two ISR G1 (1811 and 1812) that have a GRE tunnel between them.Without any crypto protection I was getting around 3.6 MB/s in regular Windows SMB transfers. After employing crypto protection to the tunnel I'm now only getting 2.7 MB/s ...
Hi @Giuseppe Larosa Thank you for your reply. You're right that it will involve the CPU at some stages during operation, initial setup, when a BFD event triggers, etc.I guess what I'm seeking is to know for a fact that the BFD packets during normal o...
Hi @Sergiu.Daniluk Ahh great, thank you for the tip. I guess they forgot to move that to the corrosponding section for the v9.x upgrade documentation :) I'll give it a shot. Thx :)
Hi all Does anyone know what the commandhardware profile multicast nlb actually does?I can find zero documentation about that command and I'd like to know if it imposes any behavioral changes for existing multicast traffic.Thanks
Hi AlexDid you ever get to implement this?I'm thinking in particular for the "hardware profile multicast nlb" command?There is no documentation for that specific command.
