Network Security

Hello, Good Day! Just wanted to ask if you encountered this issue HI_CLIENT_OVERSIZE_DIR on the FireSIGHT Management Center Intrusion Events? If yes,  what are the best recommendation to handle this? Thank You. vrian

Hi, I am using cisco asa 5505 with 9.2(3) asa version. I want to use it as dual wan both PPPOE but only one PPPOE Works at a time. Here is what i have created. Two VPDN GROUP one for each PPPOE Connection. Outside1 --- Vlan2 Outside2---Vlan999 If i...

HelloI'm looking at getting OGACLs working on a WS-C3850-24P (03.03.02SE with IPServices Licence). The link below shows object-groups being used with ACLs on a 3850:http://www.cisco.com/c/en/us/td/docs/ios-xml/ios/sec_data_acl/configuration/xe-3se/38...

Hi All, I would like to White-list only few websites (http and hattps) by FQDN (Domain Name) Instead of IP address in Cisco ASA 5505 and the rest will be blocked.

Hi Experts.                            I would like to know about of Firepower . Can I configure ASA 5525 Firepower Service with ASDM . I can not see Firepower configuration Tab at the ASDM . Please help me and Thanks. ( Some people say me to configu...

Hello, Does ASA support MLAG.  I am checking recently connection between ASA to switch via Etherchannel and find a terms of MLAG.  Could you please advise? Thanks!

Hi All, One of our client requested to allow one url hosted in internet. Destination ips are too many but at a time only one will be in working state,they keep changing the destination ips in a short time interval. Is there any solution is available ...

Hi ; i have 2 interface in my cisco ASA Version 9.1(1) interface GigabitEthernet0/0 description  Internet Circuit nameif Internet security-level 0 ip address X.X.X.X  255.255.255.252 interface GigabitEthernet0/1 description DATA VLAN nameif DATA-LA...

Hello, I recently discovered an older tool to assist in blocking malicious IP addresses. It seems the tool is no longer available. I was looking for a similar tool. I tried to download it, but to no avail. The open source tool is called blocklist2ac...

Hi Team,   What is command to see frame discard on ASA5585(9.1), sub interfaces, The Firewall is configured in multi context mode.

Morning / Afternoon I have an ASA 5508 that at present seems to be working on the whole ok, up until I added a new network to one of the spare interfaces. Directly attached to the ASA is the; 'Outside Interface' - connected directly to our ISPs route...

Hello All, If i am trying to access FW separated server and im getting reset packet on FW, who generates it. As in destination server generates the reset packet or FW itself generates it.

Had this problem today with ASA 5516-X on ASA v9.5.2-14.  Essentially the firewall stopped forwarding all between connected interfaces/subnets.  From the firewall console, I could ping pretty much anything in the network and on the internet.  But fro...