We have defence centre 3D 1500 ver 5.3.1 and we have ASA ver 5.3.1 ( ASA 5555-X 5512-x and appliance running 5.3.0.1 ( 3D 8130)
WE require to upgrade defense centre to ver 5.4.1.6 .for upgarde process do we have to upgarde to version 5.3.1.6 the...
Dears
when i select users while creating a new policies I get the attached error.
i have some queries for the access control policies
Rule 1: action: block , ,zone: inside to outside,, source :any destination: any url : high risk url
Result wil...
Hi Cisco people,
I am running lab on GNS3 in which I am configuring ASA but the configuration is not getting saved , in the sense everytime I save project and start the ASA again, all saved configuration is vanished and so I have to do it again.
AS...
Hi,
I am new to the world of networking and firewalling (I am the SAN/VMware who was given the "you are the network guy tshirt)
I have a ASA 5508-X running 9.4.
My remote VPN users are currently connecting and are getting IP's from the local IP po...
Hello All,
I need to know how many access-lists i can apply on the outside interface of ASA.
If only one then i already have a access-list running on my ASA which is:
access-list OUTSIDE-IN-ACL extended permit icmp any any
and i have applied to th...
Hi,
we are using Cisco ASA 5505 Vers. 9.2(4) with basic license (2 VLANs and dmz restricted) with the following configuration:
interface Vlan1 nameif inside security-level 100 ip address 192.168.200.32 255.255.255.0 !interface Vlan2 nameif outside se...
Running an ASA 5515-X, version 9.3.2.1(9) of CX, have malware protection turned on, and using the default web reputation profile . Some sites that are being blocked with "Access to this destination is not allowed due to a possible malware threat." me...
I'm doing PoV of Cisco ASA with FirePower with my customer. I would like to integrate firepower to MS Active Directory. Everything seem work properly.- Installation of Firepower user agent complete successfully. Connection to AD work fine. Log is GRE...
hi everyone
i have this configuration on asa:
hostname(config)#policy-map global_policyhostname(config-pmap)#class inspection_defaulthostname(config-pmap-c)#exit
hostname(config)#service-policy global_policy global
by without any inspect command,asa ...
Hello!
We had a Power outage and after that the SFR module is stuck in applying policy and is unresponsive. The ASA itself is running but the module has been like this for 6 hours. tried to reset and shutdown the sw-module but no luck.
I guess the...
Hello
Often times, IT managers at our installations are not able to properly configure the following, to allow for unrestricted traffic between end points.
Scenario:
Alarm system IP address scheme (ip 10.0.0.221, subnet 255.255.255.0, gateway 10.0.0....
Hi All,
I want to validate below information becuase i'm realy confused!.
ASA5585-S20F20X-BN = ASA5585-S20F20-BN + security please license + redundant power supply
both S20F20X and S20F20 are the same Hardware
waiting for you help experts.
...
We have an ASA 5515-X and recently purchased the Firesight IPS Module. I was wondering if anyone had recommendations for a Dell Server Setup to run ESXi for the OVA. Ex: RAM, Processor...ETC.
Thanks
We've been running 6.0.0.1 for a month or so and we've encountered quite a few issues/bugs. We upgraded to the 6.x train at the suggestion of TAC to fix an issue in 5.4 we were having. Because of all the bugs we've hit, and the impact of some of th...
