Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I was asked to implement this: 2 firewalls HA connect to 2 Internet circuits for redundancy trough switch either catalyst or small business switch SG- 500/300/250. I dont like this not-standard setup and I'd connect firewalls directly to the ISP ...
Hello guys, we have 3 cisco sbc 350 -48-fp-4x and connecting ip phones and pc to them via single port. The problem we have - ip phones are not detected on the random ports of all 3 switches : switch1- 19 ports , sw2 - 12 ports , sw3 - 42 ports not ...
Hello experts. There is task : sip videoconf devices are on private network and they need to connect to cloud vconf provider, to make them reachable with other devices in that cloud. Vconf provider is telling me to assign public ip for each sip vcon...
HI, I need to pull data from multiple remote CME , like DN, ph mac address, username. I could pull that from web interface (Configure>Phones)in good format BUT when I compared with results from cli command show ephone , I didn not find any matches be...
Hi , we have users with jabber on the iphone having problem to dial out. With the same settings on the csf desk pc jabber can dial out . On the trace I see iphone jabber sending [email protected] and receive unallocated number, while de...
2 circuits, each CE modem has only 1 port so only 2 ports uplink A&B, AND 2 firewalls each with 2 wan ports C/D & E/F, firewalls in HA mode. We would like to have C&A, D&B from1st firewall and E&A , F&B from 2nd firewall for redundancy. On the...
yes, and I think its because of iphone jabber is sending name instead of number in the URI . Where is this can be changed? WHere is jabber pulling caller id name is it from AD directly or from End User config in CUCM (is it user id or Directory URI)?
