Hello customer asked that he want to ping/telnet ACE VIP from PROD server, is it recommended ?if so how to do that
Hello customer asked that he want to ping/telnet ACE VIP from PROD server, is it recommended ?if so how to do that
Hello everyone, this is my first post here. Looking to get some assistance with what seems to be a basic issue with ASA firewalling. I've worked in the Route/Switch field for awhile but now will be working quite a bit with ASAs. Until recently, I've ...
In Cisco ASA Active/Standby State-full Failover, what is the difference B/W Failover LAN link and Statefull Failover link.I understood how to configure.also we can use both LAN & STATE link as a single Interface, for best practice use as separate ...
Hi, We are planning implement the firesight (Virtual) on central site to manage 4 remote ASA, is it recommended? Tks
Been running 8.4(7) load line for over a year now. I'm looking at the release notes for 9.1 and higher releases, and I don't think we'd use most of the new features, mainly clustering. I did notice that beginning in 9.2, BGP is supported. It's possib...
Hi to all,I have an Cisco ASA 5550 which is configured to establish VPNs with Cisco AnyConnect Clients. With the PCs work fine without problems, but now we need to establish the VPNs with the new Windows Phone 8.1 that we have purchased. If I establi...
Hello Experts,I want to block access to a website which is running on multiple IP addresses (changes every time) but keep the following points in account:a) I'm using ASA 5505 and other Cisco switchesb) I don't have any content filters like Websense ...
Hi Everyone,We have server with public IP and users from outside internet need access to it.On firewall outside interface i config the ACL to allow access to server on certain ports.For traffic back from the server i need to config the NATOutside int...
Good day all, I'm in a bit of a pickle.We have a new 5585X running ASA 9.1(6)6 with ASDM 7.4(2) in HA configuration.It's working fine for our normal traffic and I have it passing log files from the DMZ to the log server; however, trying to get a DMZ...
I have been asked to install two firewalls 5512x on some site , one of the most important requirements is web security filtering , but unfortunately I found what they ordered is 5512-IPS-x with base license and without SSD hard disk ,so how we can...
I have two identical ASA 5515x's. One has been configured and one is fresh out of the box. Due to changes that are being done to our server room I wont be able to put them in failover. 1.)Would it be possible to get the config from the active one to ...
A couple of days ago the receiving interface utilization on our ASA's outside interface spiked to over 100 times what's normal. Below are some show commands I ran. I'm not great with firewalls, so any help at all is appreciated. # show trafficinside:...
Hello I have recently replaced the csc module of an asa 5510 and now I am ready to configure asa again to send all traffic to the new csc module.I think it is something with server policy rules but I need a step by step guide to do it. Thank you!
hi,i configured Cisco ASA 5508-x connected to switch, when i tap into native vlan using Rj45, i got an ip address of 192.168.0.x which is good and also i can browse the internet. but when i tap into VLAN 2 or the other VLAN's, i can get an ip address...
Hi All. Just having a problem with port-forwarding on ASA5512 v.9.1. The configuration the same as used for port forwarding but it doesn't work.I need to forward port 443 from outside interface to local device. Local device ip is 192.168.1.90 and SSL...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
| Subject | Author | Posted |
|---|---|---|
| 05-05-2026 09:59 AM | ||
| 05-02-2026 06:09 AM | ||
| 04-30-2026 12:46 AM | ||
| 04-24-2026 07:04 AM | ||
| 04-22-2026 11:56 AM |
| User | Count |
|---|---|
| 9 | |
| 2 | |
| 2 | |
| 1 | |
| 1 |