Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Resolved! Range of ports

Hi Guys, Can you please help me with configuring a asa 5505 8.2(5) with a range of ports.I have set ACL -  access-list firewall extended permit tcp host 1.1.1.1 host 2.2.2.2 range 4800 4900what is the easiest way to add the static (inside,outside) fo...

ohgroup01 by Community Member
  • 848 Views
  • 3 replies
  • 0 Helpful votes

I've got an ASA 5505 firewall, which works fine most of the time. However, sometimes when I save the config to flash the ASA will freeze (amber light & all lights flashing on the ports). I've read on the internet that this symptom is due to faulty RA...

Huw Jones by Community Member
  • 1047 Views
  • 3 replies
  • 0 Helpful votes

Resolved! URL filtering

Hello community!I was reading the following article: ASA URL filtering without a Websense and I have additional questions regarding that process.Is my understanding that the website denied is denied globally thanks to the command service-policy globa...

In the document:  FireSIGHT System User Guide Version 5.4.1 under section: Controlling Traffic Based on Users​What is being referred to as series 2 or x-series??? Is this a Firesight S/W version or:1) Series 2 = ASA5585-SSP-SFR-5,10  (Firepower modul...

cciementor by Community Member
  • 1213 Views
  • 1 replies
  • 0 Helpful votes

I currently have a Cisco ASA 5505 setup with a Site to Site VPN to a remote branch and the tunnels are live and working fine currently.I can access machines on the other branch subnet as well as ping anything on it but I cannot tcp/80 (HTTP) into any...

jhazucha27 by Community Member
  • 795 Views
  • 3 replies
  • 0 Helpful votes

New to the Virtual Defense Center and ASA Policies/Rules. Looking for tips and best practices on the setup of policies and rules in my Virtual Defense Center. Not seeing very much traffic as far as Malware and File Events, which could be a really goo...

Eric York by Community Member
  • 2540 Views
  • 8 replies
  • 0 Helpful votes

Hi As we know, failover has special ip address to connect primary asa and second asa. For example 1.1.1.1 and 1.1.1.2. Do you think that other device or other failover asa can use the 1.1.1.1 and 1.1.1.2 in the local network ? Thank you. 

eigrpy by Level 7
  • 585 Views
  • 3 replies
  • 0 Helpful votes

HiI am new to configuring Anyconnect VPN using the command line. Previously I have just used the Anyconnect Wizard using ASDM. I need to configure anyconnect VPN and I want to start using the command line. I have 2 questions for anyone kind enough to...

Hello community I am not being able to add our  ASA 5585-X Cluster to CSM. we are running ASA 9.2.2.4 and CSM 4.7. (error on the print screen). Do you think an upgrade will help? As anyone tried or found a solution for this? Best regards Isaac 

Review Cisco Networking for a $25 gift card