Network Security

We have an existing ASA 5510 running 8.2, and have added an ASA 5505 running 8.4 at our secondary location. I have created a site-to-site tunnel that shows UP and working, but when a connection is attempted, the following error shows in our logs:Asym...

Hi,I'm facing the issue of not being able to access the "dmz" interface from behind the "internet" interface.Here is a breif portray of the topology:Input access list on the "internet" allows required traffic to 1xx.xxx.172.1.No nat is configured bet...

                   I able to access internet but unable to connect to tghe servers behind the ASA. I can ping the router but I cannot ping the outside addresses i assigned to the servers. I want to use rdp to connect to the servers inside from the ou...

I want to map the TCP 999-120 to the publicInternal server is 10.10.3.1891.1.1.1 is public network addressWhat should I do?ASA 5512 IOS 8.6I want to map the TCP 999-120 to the publicInternal server is 10.10.3.1891.1.1.1 is public network addressWhat ...

HI,I want to access my remote(spoke) ASA (ASDM) in my hub location..do not want to access via public IP from outside.what configuration should be done on the spoke ASA..                                               VPN Tunnel               SPOKE    ...

Hello All, First time posting to the forums. I've been working with Cisco ASA 5505 for a number of months and recently I purchased a 2nd ASA with the goal of setting up Site to Site VPN tunnel. It look so simple from the number of videos that I have ...

Dear All,Need some help on a question that i have in regard of adding in a new 6 GE module card in an ASA 5512-X. My company just recently bought an expansion module (ASA 5512-X/5515-X Interface Card 6-port 10/100/1000 RJ-45) and my role is to add th...

I have a requirement at a client site wherein I am tasked with separating VLANs near the edge.I have to have a trunk between the ASA and the IPS which will carry the two VLANs.Is this possible?Thank You in advance!