Network Security

Engage with peers and experts on network security topics such as FTD, FMC, FDM, CDO and ASA.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Cisco CyberSecurity

Labels

Forum Posts

Hi All,We have a strange problem with a PIX 515E running 8.0 (4).BACKGROUNDThe Pix is configured with two ISP connections, primary and secondary. We use a simple SLA monitor to check for reachability of the ISP 1 gateway, if this goes down ISP 2 come...

veltech by Level 1
  • 1983 Views
  • 20 replies
  • 0 Helpful votes

Version...  Cisco Adaptive Security Appliance Software Version 8.4(1) Device Manager Version 6.4(1)We have an ASA 5505 on all our sites.  The ASA is connected to a secondary ISP for redundancy.  It has an IPSec VPN connection back to HQ.  Issue:  We ...

asafirewall# show proc    PC       SP       STATE       Runtime    SBASE     Stack ProcessMwe 00c9bb24 02068500 013e3250          0 01734830 15616/16384 emweb/cifsLwe 001072ac 0177022c 013e32d0          0 0176e258 8132/8192 block_diagMrd 00223be0 018...

andy akpa by Level 1
  • 1235 Views
  • 2 replies
  • 0 Helpful votes

Resolved! ASA 5515X Design

hi all,here my Network setup, and i am going to get the ASA 5515x device .i have 3 different local network and 2 WAN connections.LAN 1 -- 10.1.1.0/24 --local usersLAN2 -- 10.1.2.0 /24 --  serversLAN3 -- 10.1.3.0/24--guest internetWAN1 - ADSL Line wit...

zeuscyril by Level 4
  • 1195 Views
  • 13 replies
  • 0 Helpful votes

Hi All, Hope some one can help me.I have spent the last two days trying to resolve this problem but had no luck.When I configure the ASA5520 from scratch every thin works fine, I can access the internet and surf with out a problem. The problem is whe...

I currently have a Cisco ASA plugged into a single AP. This plugs into the POE port of the ASA.the wireless point has 2 ssid's ( vlans ) 1 and 10both side are trunked to allow the vlans.vlan 1 is on 192.168.70.0 /24 ( production ) inisde interfacevla...

Hello, I have a issue where I need to port forward a port from the outside to a host on the inside. The outside interface is a priviate (RFC1918), which is NAT'd to an upstream firewall. The problem is rpf-check DROP and %ASA-5-305013:Topology:  Inte...

Spagsterj by Level 1
  • 595 Views
  • 1 replies
  • 0 Helpful votes

  I set up AAA authentication for traffic going through my firewall.   That causes the PINGs to be denied.   I assume that is by design.   What protocols would cause a prompt to display so the originator could traverse the FW?   I'm not sure how AAA ...

jimmyc_2 by Level 1
  • 431 Views
  • 1 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card