Hello, I have a very weird issue. Here what I am trying to accomplish:- inside server: 192.168.1.84- outside server: 94.95.96.97- port 2222 is open on the inside server94.95.96.97:2222 should go to 192.168.1.84:2222 and is allowed from ANY host...
Hello, I have a very weird issue. Here what I am trying to accomplish:- inside server: 192.168.1.84- outside server: 94.95.96.97- port 2222 is open on the inside server94.95.96.97:2222 should go to 192.168.1.84:2222 and is allowed from ANY host...
Hi,As a begineer in ASA, I'm trying to configure a 5505 to allow 3 hosts to access 4 servers in different routed networks. The 3 hosts are on the same vlan so I would think transparent firewall would work for this. The example below is from Config no...
Hi,Tried logging in via ASDM, but apperantly there is a command I need to run first.So plugged console cable into my laptop and firewall, ciscoasa> comes up, but I cannot log into it?I thought username: cisco and password: cisco were the defaults? An...
I just want to ask a question that what could be a common problem in IDSM if it is fail to ping from the configuration session screen. IDSM installed in CISCO 6509 chassis and unable to ping. But Traffic is generating and displayin...
Hello guys!I have some reports configured to send! I have a different name for each one.We have the field named "Report Description" <-- EditableWe have the field "Report Name" <-- Not editableWe have the field "Report Type" <-- Not editableSo, I wan...
I can't figure out how to overcome the implicit deny for icmp on the inside interface of an ASA firewall.I am pinging from one internal host to another, both on the inside interface.I've added explicit rules but it doesn't seem to matter.Please helpa...
We have just installed a new ASA 5515 with 9.1(1) loaded and it is our first look at this device\syntax. It has been setup as a 'translation' from another device.At present, I can ping both an external ip (8.8.8.8) and a LAN based ip addresses from t...
Hi, I have the senario below 192.168.1.0/24 (192.168.1.5 log server) firewall(A) --------------tunnel -------switches-------- firewall(B) 192.168.2.0/24Can I send logs from the switches to the firewall B and then to the firewall(A) via the tunnel wit...
Hello from Ecuador,We have a very small office with no more than 10/15 users at a time. Our ISP provided speed is 7down and 3up.We have deployed an ASA5505 in our network, and our very simple topology looks like:Cable Modem > ASA5505 ------- AP1262 ...
Hello all,I have a C887 router with IOS c880data-universalk9-mz.151-4.M4.bin. I have configured inside and outside ZBFW config, however on attempting to secure the router self zone it is blocking internet traffic from wifi users on the site. The pl...
Hello Folks,I have a Cisco ASA 5505 and I just setup a DVR system at our office. Everything works fine inside where we can go directly to the IP address 10.11.15.90, but we would like to also be able to access it from the outside as well.I am not to ...
Hi Guys,I have run into a scenario where there they use a switch stack of four 3750’s and two ASA 5540 in Active-stanby HA Pair.ASA's are connected with 4 interfaces across stack (1 interface to each switch).1 Etherchannels (4 ports) is configured be...
Hi, I am looking at below NAT statement in our system, but not understanding that what it means or whats the purpose of this statement.This NAT statement is on VPN ASA and I understand that it means ANYsource traffic on OUTSIDE interface hit...
Dear all,Accidentaly I have discovered, that idle timeout on ASA not always works as I expected.Can somebody explain me, why I can see something like this (addresses changed, but time info remained)?UDP outside:192.168.1.1/43501 inside:192.168.0.102/...
Hi All,We have 8 Mbps of bandwidth from one of our ISP, terminated on a Router (gi 0/0), from that router port (gi 0/1) is connected to my Lan1 and another port (gi 0/0) is connected to Cisco ASA (Lan2).Management has decided to give 2Mbps(upload a...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
| Subject | Author | Posted |
|---|---|---|
| 05-26-2026 07:54 AM | ||
| 05-02-2026 06:09 AM | ||
| 04-30-2026 12:46 AM | ||
| 04-24-2026 07:04 AM | ||
| 04-22-2026 11:56 AM |