I have little bit confuse how to define cisco VPN client license. My asa 5505 has below license. Does my license only allow 2 clientless VPN concurrent connection and 25 anyconnect client user concurrent connection ? Licensed features for this pla...
My ASA is 5505 8.4(4)1 and 5515 8.6(1)2I setup a 5505 and 5515 SSL anyconnect VPN. When the client computer try to connect through https:\\x.x.x.x. It prompt and check up ActiveX and Java, After that It requests to install Cisco AnyConnect Secure M...
Hi. What are the main differences between both OS's. ACL NAT creation is different are there any other obvious differences that can be summed up.
Hi there,I've been trying to enable stateful firewall rules on this router and it won't accept the ip inspect command. Is there a licence or IOS version that I'm missing or feature that I need to activate?router#sh verCisco IOS Software, C860 Softwar...
Hi all, I really could use some assistence in regards to a ASA 5510 and a 2811 Router. I have working internet, but Access lists are killing me, I am just not quite able to wrap my head around them. First off let me say what I want to do. I want the ...
Dear All ,we have five firewalls with the following details:First FirewallHardware: ASA5550, 4096 MB RAM, CPU Pentium 4 3000 MHz, Flash 256MB , BIOS Flash1024KB , ASA IOS 8.4(3) ,Device Manager Version 6.4(7) my question can i upgrade ASA IOS 8....
Hi Freinds,we have two FWSMs on 6509 boxes, inside secuirty level is 100, outside is zero one dmz has security level zero i want to create another dmz ..could someone explain me the steps to create dmz in FWSM i am not expert on FWSM also the new DM...
I am new to the world of ASA's and I am trying to figure out when I do a sh asp drop I get this output Frame drop: Invalid UDP Length (invalid-udp-length) 1 Flow is denied by configured rule (...
In ASA transparent mode, Why it is necessary to keep management ip in the same subnet to that of connected network?what if I keep management ip in diffrent subnet than that of connected network?If I do so does the traffic move through the asa and wh...
Hi,I have two FWSM's modules running in two 6500 as an active/passive pair. THe problem is that we're experiencing low throughput in some connections (about only 10Mbps).I've been doing some research and I found that ASA does TCP coalescing and in ca...
Hello,I know that the Cisco ASA Transparent Mode implementation requires a management IP Address in order to pass traffic:"For IPv4, a management IP address is required for both management traffic and for traffic to passthrough the adaptive security ...
i am pix-515e is running 100% right now. can you someone please help me? i already disabled dns, netbios h.323 ras on the global-policy. however, the cpu still at 100%fw1# show proc cpu-usage sorted non-zeroPC Thread 5Sec 1Min ...
Hi Everyone,Is it good practice to config VPN failover config on client rather then on VPN gateway itself?Are there any advantages or disadvantes of this?RegardsMAhesh
a company has at&t as the primary. and they want the cradlepoint as the failover. but the cradlepoint has no static ip. the company realizes they will only beable to surf the web if the failover cradlepoint is active. so once i have the c...
In a pre-8.3 ASA, is it possible for both regular dynamic NAT and policy dynamic NAT to share a single global address?I see two configuration possibilities, but I am not sure if either of them would work.1. Two nat statements share an ID and therefor...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
| Subject | Author | Posted |
|---|---|---|
| 09-30-2025 03:35 AM | ||
| 09-26-2025 12:33 AM | ||
| 09-24-2025 06:11 PM | ||
| 09-23-2025 04:54 AM | ||
| 08-29-2025 08:17 AM |
| User | Count |
|---|---|
| 12 | |
| 5 | |
| 2 | |
| 1 | |
| 1 |
