Hi Cisco Community Currently I have deploy FTDv with FMCv. All seem good but when want to deploy changes in FMC it shows failed. It also show inspect interruption for interface policy and security engine. May I know where to check on this error?
Forum Posts
Greetings Cisco Community, I am looking to automate the process of adding intrusion rules to a Firepower device (FMC version 6.2.0). I was hoping to be able to use the REST API for this purpose, but looking through the documentation, it's unclear to...
Hi All, Going to upgrade cisco asa 5516-x firepower module to version 9.16(x) and asdm 7.16(1.150). If i execute show version it shows only asa software image (asa982-38-lfbff-k8.SPA) and same in boot system file (boot system disk0:/asa982-38-lfbff-k...
HiI have 2 FTD's being managed by FMC. I wan my nms to show me the interface utilization of the ftds. In platform settings i added the snmp configs but in solarwinds nms when i add the device it fails the test.Need some guidance to achieve above.Rega...
Resolved! ASA replacing standby unit
Hi, I am replacing an standby ASA in a HA pair, and the guidelines I have recieved are to remove HA configuration on current active, and then configure HA again on the Primary unit. Refering to Cisco documentation on setting up HA, I am a bit confuse...
As rules below: 10 access-list 102 permit tcp any host 192.168.1.100 eq ftp 20 access-list 102 permit tcp any host 192.168.1.100 gt 1023 What is History, benefit, using gt and lt (line 20)?Is there meaning in ports sequence number?Regards.
Tried to configured interfce Redundancy config on cisco ASA below error i'm getting ASA(config-if)# nameifASA(config-if)# nameif insideERROR: Failed to initialize interface insideERROR: Add interface failed. ASA ASA(config-if)# sh int redundant 1Inte...
We have a web server behind firepower in the DMZ, and we've implemented an SSL policy for decrypting traffic with a known key. In our domain name (forexample.com), we've directed traffic to Cloudflare Proxy. Within Cloudflare, the traffic is then for...
Just wanted to know how can I summarize individual ip routes from user vpn to a summary route to upstream devices.
Resolved! DNS only works on one host?
So, I had DNS working, and I started putting FQDNs in ACLs. All were working and populating "show dns". Then I rebooted the firewall a few weeks later and now it's not resolving most hosts - saying they aren't active. The below code is partial and I ...
Greetings! I am very new to NX-OS, and it has been an uphill battle getting everything working. My current issue is that I cannot get my aaa shared keys to encrypt. They are set on level 7 but when I perform a show run, it shows in clear text on mos...
I'm currently trying to configure syslog on an ASA to send logs to a server via the outside interface. However, I'm facing an issue where nothing appears on the server. Are there any specific considerations or tips for setting up syslog on the outsid...
I'm currently trying to configure syslog on an ASA to send logs to a server via the outside interface. However, I'm facing an issue where nothing appears on the server. Are there any specific considerations or tips for setting up syslog on the outsid...
Can we create VRF on onprim FTD 3110?
Is there any chance that Geolocation will ever be available for use in prefilter rules? What I would like to do is have a prefilter rule that will exempt certain subnets from undesirable locations - just analyze the traffic and pass onto the ACP, and...
