Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Hello guys.I am having issues with NTP syncing on one of my ASA's. I configured the NTP server that is behind another ASA and both ASA's exchange routes via EIGRP.  Any help on this would greatly be apreciated.thanks NTP Server IP address: 172.31.254...

hi all,i've enabled traceroute on my ASA 5505 and behind is another router.the problem is the two device's traceroute aren't the same. i want a similar output on the ASA.is this normal or was there something i've missed?1841#trace www.google.comTrans...

Hello experts,Iam running some tests for ext vendor connectivity and when connecting my test 3560G g0/1 (access port) to ASA5505 (9.x) Eth0/5 (or any port), noticed increase in "switch ingress policy drops" (via show in eth0/5 o/p). Checked in the fo...

Cisco Security Appliance admin loader (3.0) #0: Tue May 11 08:13:03 PDT 2010##############################################################################################################################################################################...

HiI configurate ASA's in active active mode. I create 10 context's in Primary ASA. 5 context are in group1 in ASA1 and 5 conetexts are in group2 in ASA2.The problem assign ip address to outside interface of context's.I use int gi0/0 and gi0/1 for out...

Hi allWe are currently using ACS for wireless authentication. Guests register over an external Sharepoint webpage. The REST API is used to create and later delete these temporary users in ACS.Now we want to migrate to ISE. In contrast to ACS, the ISE...

Hello,I am trying to setup IPv6 tunnel to tunnel-broker Hurrican Electrics. IPv6 connection is working OK only if I disable zone security on WAN interface (Fe0 - IPv4 interface).Which protocols must be alloved to and from router?IOS version: 15.1.2T1...

mocah by Level 1
  • 7024 Views
  • 10 replies
  • 0 Helpful votes

Resolved! Source Ping on ASA

Yeah I know this has been covered already. I have the following issue. I have a two segments on the firewall, behind these 2 segments I have two L3 devices. VL622 is the higher security interface at 80 while VL621 is lower at 70.I have a static:stati...

wr3500 by Level 1
  • 12393 Views
  • 7 replies
  • 0 Helpful votes

I have been getting overrun errors on 3 different ASA 5550 HA pairs with traffic rates less than 100Mbps total.  I was told by one TAC guy to split the traffic between the two slots so that traffic comes in one and exits the other to maximize through...

Peter_T by Level 1
  • 13525 Views
  • 29 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card