Network Security

Engage with peers and experts on network security topics such as FTD, FMC, FDM, CDO and ASA.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Hi,I am pretty sure that you can't do this in previous versions and don't think it has changed in version 9.X but though I would check in with the community before righting the idea off completely.We are an ISP that does Managed Services, I am lookin...

Hi,I heard someone at TAC say that the reason there is a 9.0 code release and a 9.1 code releas--both current versions---for the 5515X is...9.0 is for ASAs without the CX module and 9.1 is for ASAs with the CX module.Then I've heard someone say...don...

lcaruso by Level 6
  • 955 Views
  • 4 replies
  • 0 Helpful votes

Hi all,In a case where my pre 8.3 NAT rules are as follows where I am NATing source IPs with their original IPs to get communication going between these various DMZs.static (INSIDE,DMZ1) 10.10.0.0 10.10.0.0 netmask 255.255.255.0 static (INSIDE,DMZ2) ...

I have two pairs of ASA's Active/StanbyISP 1 is connected to ASA 1 (Used for Internet access)ISP 2 is Connected to ASA 2 (Used for VPN only)I'm planning on setting up tracking on the cores for the failover and setup a second route to the second ASA w...

ALIAOF_ by Level 6
  • 707 Views
  • 2 replies
  • 0 Helpful votes

Hi,We are planning to set up a IPSec VPN L2L tunnel with a client. Our client is running some internal networks(didn't disclose) and will nat his internal network with X.X.X.X public ip. We also have internal networks 10.50.101.0/24 and will nat it w...

Anukalp S by Level 1
  • 430 Views
  • 4 replies
  • 0 Helpful votes