Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Hi All,Hope you can help with this one. I need a solution the following problem either additional hardware required or could it be done with current hardware?Problem:I need a way for multiple video conferencing endpoints to register to one public (ou...

ciscoKart by Level 1
  • 510 Views
  • 3 replies
  • 0 Helpful votes

                   I am trying to find out if the ASA 5515-X is EAL4 certified, and if not, what recommendations of EAL4 certified devices can I use.  

rfawns by Level 1
  • 5879 Views
  • 5 replies
  • 0 Helpful votes

After hours of trial and error, and searching user groups, I have found that on occasion, ASA v8.4 will stop pings with the IPsec-Spoofing logic.  Interestingly, the packet-trace will say everything is allowed.The fix (at least in my case, and one ot...

jimmyc_2 by Level 1
  • 704 Views
  • 2 replies
  • 0 Helpful votes

I have an ASA that keeps dropping what looks like Netbios Boradcast packets on the inside interface.  06-06-2013          13:42:44          Local4.Debug          10.1.1.247          %ASA-7-710005: UDP request discarded from 10.1.1.134/137 to inside:1...

jaysin144 by Level 1
  • 1669 Views
  • 3 replies
  • 0 Helpful votes

hi I have been reading ASA document defining how to defend DDoS attack specifically SYN Attack.According to the document ASA can defense half open TCP connection. "SYN Attacks"but what if the attack was a "PSH+ACK" AFAIK this is not considered half-o...

Hi,In order to do a flash upgrade on a 5510, is there any way to get the files from the existing flash onto the new flash before you replace existing flash? Is there an online procedure?Thanks.

lcaruso by Level 6
  • 658 Views
  • 2 replies
  • 0 Helpful votes

I can't seem to get internet access with my current config, not sure what is going on with it.  I have my cable modem connected to my ASA @ FE0/0My Wireless Router connected to ASA @ FE0/1             Wireless Network = 192.168.0.0/24        ASA Netw...

jwood1650 by Level 1
  • 11961 Views
  • 6 replies
  • 0 Helpful votes

I have a server behind an rv042 that i would like to block access to on one port from outside in.  I have configured the rule as follows:  priority = 1.  policy name<name>.  enable<checked>.  action = deny.  service <service to block>. source interfa...

mialbert by Level 1
  • 682 Views
  • 5 replies
  • 0 Helpful votes

Resolved! Default Rule Query

Hi All,This is more of a clarification request of my understanding than a support issue. A firewall is typically locked down using ACLs on the inside & outside interfaces, and there are various static NAT statements for servers that are reachable on ...

Review Cisco Networking for a $25 gift card