Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Hi guys,I have to change an old NAT config into the 8.4(2) version. i read Cisco migration Docs n everything but still im kind of confused. it'd be nice if someone can help me with this example:OLD Config:nat-control!nat (vlan12) 0 access-list No_Nat...

smehrnia by Level 11
  • 3274 Views
  • 7 replies
  • 0 Helpful votes

Hi Experts,Just curious why Cisco's ASA doesn't support PBRs(route-maps) for next hop manipulation?  Also, why is its WCCP implementation is so limited that it can only redirect wccp traffic on the ingress where the source and wccp device is on the s...

Hello,I am preparing a zbfw design with 400+ ISR/ASR remote  routers, Flexvpn and 1 vrf.  Each router has a tunnel for visitors and another tunnel for normal users. Config below. In the documentation, I read "All interfaces in a zone must belong to t...

Hi Everyone,I was reading this from cisco live--Configuring layer 7 inspection1.Create a Layer 7 class map to identify traffic by matching criteria specific to applications:  2.Create a Layer 7 policy map to defend against Application Layer attacks b...

mahesh18 by Level 7
  • 1943 Views
  • 5 replies
  • 0 Helpful votes

Hi everyone,ASA  is config for failover which is Active /standby.Command line shows failover as active and standby.But under ASDM,Licensing ,Activation key it show as FailoverActive/ActiveIs this by design that it show as active/active?RegardsMahesh

mahesh18 by Level 7
  • 1089 Views
  • 2 replies
  • 0 Helpful votes

Hi all I’m having a problem getting hairpin nat to work on my ASA5524X Code 8.6I have some services sitting in DMZ_943 these are https services and are accessible from outside the network on a public ip address x.x.x.155 all works fine.We have a set ...

Hello,We have recently implemented a new Cisco ASA 5512-X firewall replacing and old Cisco ASA 5505 Firewall.We have a number of issues which we are encountering and have so far been unable to rectify. The config was copied visually across to the new...

jpdalton1 by Community Member
  • 1099 Views
  • 0 replies
  • 0 Helpful votes

Hi All,I am getting an error while trying to log in to the CSM. The error is as follows:"CMF session-id cannot be assigned. Please confirm the server is running."All the services are running and I restarted the service and server as well. tried the s...

Resolved! ASA basics

                  Dears please correct me if im wrong , i have a question by default when im configuring ASA , i'll have only 1 exit interface , 1 internal , 1 DMZ and will apply my policies to this interfaces however if i need to apply different ext...

Review Cisco Networking for a $25 gift card