Network Security

I have a cisco asa 5520. i need to forward telnet to a router on the inside interface. Here is what i have done so far but it doesnt seem to be working.I have created an access-list that looks like this:access-list 102 extended permit tcp any host 10...

i am currently looking at the suitability of replacing an 'airbreak' firewall with 2 new ASA 5505'S.One stipulation i have is that i require to connect the third party that is currently using the 'airbreak' solution using a secure iPsec VPN.I have bo...

At the moment we want to connect the ASA on two seperate internet connections . We create one LAN interface and two WAN interfaces. Now we want to create nat rules nat our outgoing traffic. After some research and testing (on a 8.0(4) asa) we have it...

I have a new 5512-X with the built in IPS sensor. The firewall is running in transparent mode with the management interface being used for both the ASA and the IPS sensor. i.e. a single interface.Both the IPS and the ASA are configured on the same ne...

HI , I have 20 mbps internet link and I have ASA 5505 . I have to divide this bandwidth 10-10 mbps each for Voice and Data . So that both can work properly. because when I am using it for both on same interface, I am getting Voice disturbance.. Pleas...

Hi, I've read several posts and configuration documents including: http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_tech_note09186a008084de0c.shtml#rateand http://brian-kayser.blogspot.ca/2010/10/doing-asa-quality-of-service-qos.htmlBut...

Hi,I need to make a report of the VPN history on an ASA 5510 and I cannot find a way that fast.Please some info/tips.Thanks in advancegreetings,Pim van LutterveltSystem Administrator

Case closed

Hi everybody ! i just deployed Cisco NAC version 4.8.1 Virtual Gateway OOB on a LAN envieronment and on a WLAN envieronment, it works fine for some users , they can authenticate via the agent or web page, and then they are redirected to the access vl...

I have 2 x ASA acting as default gateways the two can ping each other but when i tried to ping the far end devices like servers from one of the ASA it does not ping.dc3-fw1# ping 192.168.98.13Type escape sequence to abort.Sending 5, 100-byte ICMP Ech...

Dear All,The ASA is configured to send the syslog messages to syslog server.I just want to know how can I display (view) those messages from the server, and will this overload the server after some time? how can I check the load status?Your help will...

Hello,I have 2 ASA and would like to build a Side-to-Side VPN between these ASA. So I can learnsomething about configure a ASA for different thinks. But now I don`t can Ping from a Clientto the Internet-Router.My Configuration is:Client IP 192.168.1....

Hello all,I have an asa-ssm-10 module with software version 7.0(2)E4, and was wondering when or if I should upgrade.  There doesn't seem to be any issues with the IPS, so if it were a switch or router I wouldn't think I need to, but with it being an ...