Network Security

Dear ASA Guru,Is there any feature like Link State Tracking in Catalyst for Cisco ASA. I want to shutdown another interface if one interface is down in Cisco ASA.Best Regards,Rizal Ferdiyan

Queery regarding vpn tunnel on router say on site A below are isakmp policycrypto isakmp policy 10authentication pre-sharegroup 2encryption 3deshash shalifetime 86400crypto isakmp policy 20authentication pre-sharegroup 2encrption aeshash md5lifetime ...

Hi,One of our customers every now and then reports of a problem about the FTP connection hanging for tens of minutes. The storing and retrieving of files is done from a remote server thats behind a L2L VPN connection. The FTP transfers are done every...

VPN Client 5.0.03.0530 works fine. Connection is ok. When disconnecting the VPN connection, Windows gives the following message: Windows detected an ip address conflict... What can this be ? This problem occurs on all Windows Vista laptops. Not yet t...

Dear boss I m using ASA5510 for DMZ. Please see my attached diagram and configuration.interface Ethernet0/0 nameif local security-level 100 ip address 192.168.0.243 255.255.255.0!interface Ethernet0/1 nameif outside security-level 0 ip address 10.0....

Hi folks, I'm currently working on converting some PIX firewall configs to ASA and wanted to check I was on the right track, as I don't currently have the ASA's so doing the configs up front! Everything seems straight forward in the conversion and I'...

Hi there,I want to ask for the possibility of configuration below? Any feedback and advice are warmly welcomed 2x Cisco ASA 5510 running Multi-Context mode and Active/Active Failover1 Cisco ASA 5510 (ASA 1) has AIP-SSM1 Cisco ASA 5510 (ASA 2) has CSC...

So i got my hands on a Cisco Adaptive Security Appliance 5505. Nifty little toy I'm trying out, just need some config ideas. What i want to do is set up the ASA as my main gateway to the inter-webs, just not sure how I'm gonna do it. I currently have...

Hello EveryoneCurrently we have two ASA 5580 in failover (Active/Standby) mode and the current version is 8.2(4),we need support ragrding some concerns1-We have problem that when we do dynamic NAT for internal zone to outside zone we have to perform ...

We currently had to RMA both PIX 525s due to increasing crc errors. After swapping the old ones with the new we are still seeing crc errors on all gig interfaces. We have swapped the gig nic's and the sfp's and the fiber patch cables, yet still the c...

Can a firewall show more XLATE created than CONNECTIONS?Is that theoretically possible to have more XLATEs than the total number of connections?. the reason I am asking, that assuming a Cisco 5510 has have maximum 130,000 total connections, however x...

Hi there, We have an issue with our current ASA 5505 set up and I hope someone can help.  Here is the setupISP Handoff -> L2 Switch -> VLAN 1 of ASA                                      -> VLAN 2 of ASAThe ISP handoff is a single ethernet cable but t...

hi all,   I want to know the ppoe configuration in asa5505 firewall. IN my office i have a asa5505 and i get conncetion from local isp which is nothing but ppoe connection so how to do this.regardsaslam mohammad

Does the ASA5520 work with the newest version of h.323?Sent from Cisco Technical Support iPad App