Hi Guys,Getting this log on ASA while I'm trying to ping from switch that attached to ASA and new ASA interface. Could you please advise?Thanks Nik
Forum Posts
Hello All, We have Cisco FTD pair configured with HA. Recently we have updated the FTD with 7.0.5 version with this we have also upgraded snort-2 to snort-3 (as per recommendation). Both the requirement has been completed properly. But .. Post than a...
Resolved! FMC/FTD Upgrade matrix question
Hisee image belowI was planning on upgrading to 7.05 which looks now to be cisco reccomended version, but after double checking the matrix it seems that thats not an option as if I upgrade FMC to 7.05 it wont be able to manage the FTD's, version 7.2 ...
Looks URL filtering was enabled on a policy with different categories like Gambling blocked but unfortunately few of them are still accessible. I gone through some Cisco document, it's mentioned that https inspection for url filtering only works for ...
Our environment consists of two identical FPR-1140's running ASA version 9.14. We have them set up for failover, and everything works properly if one of the devices were to fail. However, every time this happens it seems to bring the management line ...
I'm trying to upgrade my customer firepower 1150 device from 7.0.5 to 7.2.4 version and upgrade fails. it says: ftd onbox upgrade failed.
Hi All,FPR1120, Can this device be used as an ASA itself? Currently we do not have license to CDO( to migrate the ASA config to FTD. However, we are in plan of purchasing it. In the meanwhile we need it to be used as ASA till we get the license sorte...
Will two FPR-1010s connect to each other with no issues if one of the FPRs does not use the command listed below? Also, I'm going to apply the High Availability config individually to both devices first and connect them to each other afterwards. Anyo...
Hello , I have received these sort of alert on couple of FTD in a cluster and trying to figure what these mean and ways to address this. it on 9300 firepower module. If anyone have gone through and can share would be highly appreciated Health Moni...
Resolved! Failed to Generate Report on FMC
hi guys. need your advice regarding below issue. We tried to create a Report Template to generate a 1-month report on our active firewall, for several report sections:a. Connection eventsb. Intrusion eventsc. Malware eventsd. Vulnerabilities However,...
Resolved! CyberOps Associate or Network Security?
CyberOps Associate or Network Security? What's the best option?Please I need help.Thank you very much.
Dear All, I want to reboot FTD Chassis . I would like to know the command to perform the Operation and impact on FTD/Chassis/ Production.Please help this is urgent!
Hi Team,We have got new Cisco Firepower FPR 1120 which is the replacement FTD for our ASA 5545. We need to configure the FTD as same as ASA. ASA do not have any Mgmt interface configured. So we need to manage the LAN interface of FTD as the Mgmt inte...
Resolved! ASDM history is disabled
When I go to Monitoring >> VPN >> VPN Connection Graphs >> Sessions and try to view past sessions it says ADMS history is disabled. How can I enable it? Thanks
Resolved! ASDM Help. History Veiwing
Running an ASA 5500, and using ASDM to connect. I need to view the historical metrics in graph form for traffic overview, that is shown on the firewall dashboard. I have enabled historical data, but all I see the 5 minute intervals. Thanks
