Network Security

I have been having problems accessing hosts connected via the inside interface on an ASA 5520.  The thought just occured to me that the interfaces are gigabit ethernet and the outbound connection is an 100 mb connection.  Could this be the cause of m...

I have branch office having subnet 172.26.48.0/22 one ip from this subnet say 172.26.48.100 assigned toa server . now our erequirement to access this server from outside mean from internet . tis branch office is coonected throuth leased line to main ...

Hello together, perhaps somebody had the same problem and found a way to solve it. We access our customer-networks over IPsec-Tunnel with D-Nat:Our Site is hidden behind a single Address (Service-Pat), the remote sites are accessed over /27 networks,...

I have successfully been able to allow outbound access from inbound hosts  on the appliance; however, I have only one outbound IP address and had to configure outbound access using static PAT.  What I need to do is to configure access to certain inbo...

HelloMy config:ip inspect name CBAC tcp timeout 10ip inspect max-incomplete high 100int fa0/1ip access_group permit_all inint fa 0/2ip access_group permit_all inip inspect CBAC inAccess-list on both interfaces accept all ip traffic.What happens when:...

Hi, I am trying to allow SIP communication through our Cisco ASA firewall but I get the following error in the logs. It's almost like looping with these two error message. I have removed Inspect SIP from the global policy map and configured it under ...

Hello,We can´t reach DMZ servers from other DMZ servers. It's very strange.If I make a ping from DMZ server to another, sometimes only recieve one ping, sometimes 4, sometimes 0.How can I allow the traffic between DMZ servers??(ASA 5520 Version 8.4)R...

Hi All,I have installed ASA5505 in the network. Port forwarding has been done for one of the server in our LAN. Public users are able to access the server successfully. I am trying to access from inside using the same Public server IP, but unable to ...

Recently upgraded a 5510 to Anyconnect Essentials and Anyconnect Mobile, the device was Security Plus and is now Base. Is it supposed to work this way? I lost my Gigabit interfaces. Is it possible to have Security Plus + Anyconnect Essentials?

Hello guys,I am in a middle of a dessign problem. We have 2 ISP, and we have a FWSM running multiple contexts, my context that is receiving all the static translations for all my published servers is the one where i want to configure default gateway ...

I'm trying to get a new 5505 installed in our network to replace the 1841 that died over the past few days (memory issues).  One of the big pieces of functionality that the old router gave us was the ability to open certain ports to the outside world...

Hello All,I am having an issue do DHCP from the 6500, and was hoping someone cant help. So, I tried to setup DHCP from the FWSM to the clients and this worked fine with giving out the IP, however the gateway for devices on the inside is supposed to b...