Network Security

Hi, I am migrating over from and old PIX to an ASA 5510. After configuring the new device everything else is functional (Internet) but users are unable to pass traffic when connected through the vpn, they are able to authenticate and I see their sess...

hi experts,ASA is working in active standby failover and interfaces are being monitored with help of a snmp monitoring tool.When the failover occurs the ip address gets swapped and then it is not possible to get the information of the same ASA device...

Hi,I would like to route traffic that are coming in and going out to the same interface on ASA. I am using inside interface with security-level 100.  In this URL, http://www.cisco.com/en/US/products/ps6120/products_tech_note09186a0080734db7.shtml, AS...

Hi  all,I need to implement the back up between two sites I have router 2800 which is having a point to point connectivity with the far end.At the far end there is no router ,only one firewall is there on that firewall one access-list is there to all...

Hello,I actually have a config like this :Main Site  -- cisco 3750 -- ISP SDSL router -- ISP MPLS -- ISP SDLS router -- cisco 2821 -- Remote Site                                                                         |                               ...

I am trying to find a signature that will tell my IPS to notify me when it sees any IP source address come from the network behind my IPS that was not in that subnet range.  Is there an existing signature I may have looked over in my IPS or has anyon...

hican someone help me with this? i have a active/standby pair of asa 5520's, i can access the active asa but not the standby asa via console,i have tried the password recovery on the standby unit but it does not work, do i need to remove the unit fro...

hi everybodyi have a broblem with my ASA 5510 (8.4(2) ), sometimes the static nat stops working , clearing the tan table , does'nt solve anything , reboot does nothong too, even if the configuration was right. whene i change the configuration , for e...

Hello!I'm configuring NAC appliance in L2 OOB Virtual gateway.Task:When users without CAA try to access the network they forfarded to web authentication. Depending on credentials provided user is assigned to guest role with appropriate VLAN or asked ...

Hello,I'm trying to configure AD SSO. There are two 2008 R2 AD servers in domain XXXX.LOCAL and I'm trying to configure AD SSO without ktpass.I've configured user NACUser on one servers in Users and performed ldp.exe configuration for this user with ...

I am trying to get my PIX at home to work with my home network.  I have right now a modem hooked into WAN port of the linksys wireless router.  I'm trying to put my PIX in between.I have hooked laptop straight into the modem to get network stats...th...

hi all,we have a internal URL, that works fine when we bypass ASA and doesn't open via ASA, I have tried the steps as adviced in the following link but issue still is same.http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_tech_note09186a...