Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

All I want to do is  have VNC connect on port 5950. So I want to forward traffic coming in  on the external ip address on port 5950 an internal ip address on port  5950. Here is my config:Building configuration...Current configuration : 21370 bytes!v...

jsandau by Level 1
  • 2672 Views
  • 17 replies
  • 0 Helpful votes

Hello Experts,I have ASA 5510 firewall box that needs to be configured from the scratch where-on the old start config has been removed and now when i create V-LAN then it's not making.Even the rest conf has been done successfully w/o problem. When i ...

ray_stone by Level 1
  • 611 Views
  • 6 replies
  • 0 Helpful votes

I just replaced my PC, and reloading all monitoring software. I loaded IME 6.x, and added 3 devices (ASA AIM-20 Primary and Failover, 4240 sensor).Then, I remembered there was a newer version (7.0.3), so I downloaded that version, and installed. Ever...

rsmith by Level 3
  • 1624 Views
  • 5 replies
  • 0 Helpful votes

Hi GuysI am not able to ping from 10.140.1.129 to 10.120.1.1 and getting following error msg on pix.Deny icmp src abc_dmz 10.140.1.129 dst inside 10.120.1.1 (type 8, code 0) byaccess-group "ACL_abcI already have access list from 10.140.1.129 to 10.12...

Could someone let me know how to setup access to an inside host (I am not doing any NAT'ing - no RFC 1918 address), which uses all Public Addresses on the inside from the outside interface using ASA IOS v8.3.  I tried (for testing only) using a "perm...

rafrancis by Level 1
  • 848 Views
  • 8 replies
  • 0 Helpful votes

two pix connect by failover cable and state interface.when we connect failover serial cable , found primary unit inside/outside interface down.  state interface is ok.after we disconnect failover cable, primary unit inside/outdise interface turn up.p...

fly by Level 2
  • 976 Views
  • 12 replies
  • 0 Helpful votes

I upgraded our ASA5540 to 8.4, THEN noted the increased requirements for Memory.I purchased the 2Gig upgrade, but when installing in the Primary unit today, noted that there were 4 slots.Slots 1/3 had 512Mb modules, so I installed the 2 x 1Gig module...

rsmith by Level 3
  • 2405 Views
  • 1 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card