Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

I upgraded our ASA5540 to 8.4, THEN noted the increased requirements for Memory.I purchased the 2Gig upgrade, but when installing in the Primary unit today, noted that there were 4 slots.Slots 1/3 had 512Mb modules, so I installed the 2 x 1Gig module...

rsmith by Level 6
  • 2719 Views
  • 1 replies
  • 0 Helpful votes

Hi,I need a firewall that has an absolutely worst case throughput of 500Mb/s sustained with all security features enabled.I'm looking at the 5550 platform as meeting this requirement, but would like comments.Does the way Cisco specs their throughput ...

lcaruso by Level 10
  • 1118 Views
  • 2 replies
  • 0 Helpful votes

I have just finished setting up two ASA5510s in Active/Standby Staeful failover, using the Management interface for both failover and state. Everything appears to be working well.Configurations were transferred and the "sh failover" on both accuratel...

wwiedemann by Community Member
  • 691 Views
  • 1 replies
  • 0 Helpful votes

Hi all,I have a problem getting my ASA 5520 boot properly. I first though of a flash problem and did a flash erase in ROMMON, then it brought error 15 during boot (No images found in / Error 15: File not found). I then TFTPied and image from Rommon, ...

bassono_t by Level 2
  • 1369 Views
  • 3 replies
  • 0 Helpful votes

I am troubleshooting a s2s vpn between an ISR871 and my ASA5520 and I suspect a problem with my crypto-maps.Is there a way I can display an access-list on the ASA and have the object names substituted with their IP addresses?Thanks very much.John

ForumI am working at a client site today where we are using some packet captures on the clients ASA to perform some problem resolution.When I perform a "sho capture" on the ASA, I have this output:ODEC-ASA# sho capturecapture X type raw-data interfac...

hi all,i got one mpls ip-vpn line from our isp . it is working good i can communicate my other offices.but now the problem is i want to register some avaya phones in the branch office.but my avaya server is located in headoffice.i can able to ping my...

zeuscyril by Level 7
  • 1005 Views
  • 2 replies
  • 0 Helpful votes

Hi everyone,I want to confirm if the upgrade license (ASA5505-SW-10-UL=) is backward compactible with PIX 501 firewall device?though pix 501is end of life bit i want to verify if the upgrade license for asa5505 will work with it?thanks..brsam

rahman001 by Level 5
  • 1272 Views
  • 4 replies
  • 0 Helpful votes

Hi,We have a FWSM running on multiple context on our network, and recently we found from ' sh service-policy' the FWSM is dropping some of our xdmcp packet.Inspect: xdmcp, packet 16208, drop 81, reset-drop 0here is the running configuration for the s...

filterfilter by Community Member
  • 1397 Views
  • 1 replies
  • 0 Helpful votes

Hi everyone,  I'm having an issue, with an WS-SVC-FWM-1-K9.  The card doesn't boot properly, it tries to boot, but after a while the 6500 puts it in shutdown.  I've noticed that it has 2 RJ45 ports in the board, I've plugged my console cable, but i o...

PT-TAC by Community Member
  • 1086 Views
  • 3 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card