Network Security

Hello Guys,S.O.S....Right  now, every one can go to ASA FW via browser (ip address specified on my  outside interface) and connect, download certificates and AnyConnect  client with assigned uname and password.What i am trying to do is:Configure  my ...

I have my PIX 515 setup to sync time to one of the Naval clocks, and it seems to be working fine. I would like to have my Windows Active Directory server sync its time to the PIX what additional steps do I need to take?

Hi,One of my customer is having problem to login to the ASA at the privilege mode, He has access through ASDM. He has changed the enable password through ASDM but no luck.  Here is the config:aaa authentication ssh console Radius LOCALaaa authenticat...

We have several partners in different countries who are using overlapping subnets on their switch hardware.  we have to manage all the partners hardware from our netmanagers which are installed behind an ASA5510 firewall. We have a single port to the...

Hi,I have 2 problem in IPS-4255-K9. my network has 2 device of IPS-4255-K9 and each have different problemProblem no 1:My  IPS-4255-K9 after running for 1 hour or less than that starts to hang and all the traffic is blocked as it is inline mode.Probl...

Hi,Reading through the documentation recommendations and I would like to configure the following setup http://www.cisco.com/en/US/docs/security/asa/asa83/asdm63/configuration_guide/ha_overview.html#wp1095702 scenario 4, figure 58-6 but I can't find s...

I have to make several changes in the configuration due to our company switching Internet Service Providers.  Is it best to do a "show run" at the command line, then just copy/paste new config into the ASA?  Or is it better to run the "more system:ru...

Hello,Sorry for the basic question, but does anyone know how many ACL's is supported on a ASA5550?I have a client that is looking to move 7.200 ACL's from a Cisco 2800 router to a Cisco ASA5550 and would like to understand the below:-How many ACL's i...

ASA version 8.2I ran the IPsec wizard on my 5510 for remote access.  It would seem that by default ISAKMP is enabled on both the inside and outside interfaces.  Furthermore, my default dynamic crypto map is enabled on both the inside and outside inte...

Hi,Notifications are not being sent within ciscoworks 3.2. Trying to edit or add the SMTP credentials we receive the attached errors.I have added the NOS.log as well. How can we fix this?Thanks.

I'm install cisco work 2.2 and upgrade to Cisco work 2.6  butI'm not fine link download packet ciscoview for LMS 2.6  becouse customer can't see model in cisco view.I'm need download packet ciscoview router 12000 series , Router 2800 series and route...