Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
The switch stack running XE software version 03.03.02E has been upgraded to version 03.07.01E.After the stack came up the WLAN is inoperable, the 2.4G and 5G bands on APs seem to be disabled:3850#sh ap dot11 24ghz summary AP Name ...
Hello,I have a problem at the posture checking phase. NAC agent fails to check for posture compliance and remediation never takes place. The client browser is beeing redirected to the following URL: https://ise.xxxx.yy:8443/guestportal/gateway?sessio...
We have upgraded SCE, SM and CM from ver. 3.5.5 to 3.6.5. CM and SM are installed on servers running CentOS 5.6, SCE box is SCE1010 with GigabitEthernet.The SCE was upgraded using SCA BB wizard, using scos-v365-b489-sce1000-k9.pkg for firmware and SC...
Hi,where can I find technical specifications on IPS 4260 & 4270 devices? I need some more details, e.g. throughput, and how does specific functionality affects performance, max number of connections, details on failover and anomaly detec tion, number...
Hello,just for a record, we had the same issue here, Cisco 4500 switch does not need LLDP enabled and Avaya phone gets IP address. However, with Cisco 3750 and same port configuration DHCP packets were dropped (or maybe encapsulated using old VLAN ID...
Hi Mohammed,as the TAC engineer and developer said, the problem is in the CA root certificate that was imported in DER format.Try exporting the root CA certificate (not the one issued to the ISE node by the CA, but the one that is in the Certificate...
Hello Vikas,thank you for the hint.I have followed the procedure several times but still have the issue.The TAC case has been opened and for two months I have received only few replies. The problem could be in the certificate issued by the local CA o...
You get this error if VPN tunnel protocol not specified correctly, on ASA 8.4:# vpn-tunnel-protocol ?group-policy mode commands/options: ikev1 IKE version 1 ikev2 IKE version 2 l2tp-ipsec L2TP using IPSec for security ssl-cli...
Thank you for your reply.What is exactly PQI file and where should I find one?During the upgrade the .pkg and .spqi files have been installed, as those files are available for download, but where can I get .pqi file?Best regards,Kreso
