Network Security

I have a Cisco ASA 5505 as im trying to set up with the following scenario: I need eth0/0 - Outside that get its IP from a DCHP withing my ISP’s netThen I need eth0/3 - Inside that run DHCP 192.168.1.100 – 192.168.1.250 with normal Internet access an...

Hello people. I allready asked this question in the Anandtech-forum, but I could still use an answer:(..) I could really use some advice about the Trend Micro module. The spam filtering seems to have only 3 levels, but even when I set the used method...

Hi,I need to create NTP server and clients on my network.I have a core 4507 and access 2960 series switches.Would like to know if there is a hardware clock built in for the cisco 4500 series switches, if yes I am planning to make it as my NTP server....

HiWe have just installed a Cisco 5510 for one of our customers in place of a ClearPath firewall.  The problem is the old firewall had the capability of forwarding all Internal Web traffic to the MessageLabs external Web filtering service (proxy1.eu.w...

Hello,I am not quite sure this is the good place to post this but let's try:Consider that I have a switch (e.g. 4500) on which I configure a SPAN destination port connected to an IPS (e.g. 4260). This is quite a standard architecture.My question will...

Dear All,Could you let me know more detail about IPS module on ASA? i was read document on IPS but still not clear about this .Could you let me know the main point that we need IPS on the system?Best Regards,rechard_hk

I am currently configuring an AIP SSM module on an ASA, and I would like to know which interface IP address should be used for the management interface.  Should it be the outside interface of the ASA or the inside interface of the ASA?

How good is asa5510 as firewall.  Becasue someone try to convice me that asa5510 is not good firewall becasue when we create owa or remote access connection it's hit the firewall directlly and not good.  Isn't that is with every other friewall.  Just...

I just upgraded my Cisco NAC from 4.6.1 to 4.7.2 so I could manage my 2975GS switches. My last TAC case stated that when 4.7 came out it would support the 2975GS model. However, I do not see the 2975GS as a managed model. Is that correct or is there ...

Hello All,We are migrating our Active Directory 2003 R2 to Active Directory 2008 R2 on domain controllers. Is there any known issue with 2008 R2 and Cisco ASA 5520 or the version which I am running on the  device ?I am running the following version o...

HiI have a query which is frankly stumping me at the moment.A customer has a couple of web servers on their internal network. They need to provide access from external hosts to these servers on port 443. They have an ASA5510 which has static NAT to t...