Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

I have two FWSM's in an active active configuration. Both are currently on version 4.0(6). I would like to upgrade these one at a time. Is there any problem with upgrading one to 4.1(2) then waiting a week till I upgrade the second one. I always worr...

I am in the process of setting up our 5510 to replace our current SonicWall at my place of work.  When looking at our SonicWall config I noticed that the IP addresses we have setup for our phone vendor to access the PBX systems at our various sites a...

Resolved! IDS OS reimage

I read that all the configuration wiped out after doing the system reimage on IDS device. In those cases, shall we use the "Copy url current-config" (if I took backup before reimaging) or I need to configure manually again.And I understood that, "Cur...

Resolved! ASA 8.3 PAT

Hi All,I'm well aware that there must be several posts on this topic already (I've read a few) and even searched other articles, but I am having no joy whatsoever. Perhaps this will be a chance for someone to get 5 easy points.I'm currently running a...

We are setting up a websense url-filter for our location. We have the following set up for our routers that are doing auth-proxy and we have no issues with this.    ip inspect name websenseinternet http urlfilter    ip urlfilter urlf-server-log    ip...

I have a scenerio, my outside and inside network are connected via inside interface of my firewall pix. And dmz is connected via dmz. Inside has security level 100 and dmz has 40,from dmz i can access inside lan, but not able to access internet. KInd...

I'm having a strange issue with an ASA 5520 in transparent mode. DNS inspection drops all requests from my internal dns server to the external dns servers. I also have an ASA5520 in routed mode with DNS inspection enabled in the network and dns inspe...

Hi all,Our firewall boot loop infinite, i try to stop it to getting crashinfo file but i couldn't. I used password-recovery but boot loop still exist, for ROMMON mode, no command to show files in flash or disk0. how can i do? In addition, i would lik...

Rojer-bkk by Level 1
  • 2945 Views
  • 4 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card