Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Hello,I am new to the Cisco model so excuse my lack of wisdom with this product.  I work for a small rural Hospital and we need to FTP a report once a month to a clearing house.  Problem is I can't FTP their site, I can others but not theres.  I was ...

pershingit by Community Member
  • 6073 Views
  • 15 replies
  • 0 Helpful votes

I have setup an inbound ACL on the outside interface  of my router that allows TCP ports 20 and 21 in and I have a CBAC inspect map with FTP specified on the same interface in an outbound direction.  My understanding is that the inspect will check al...

tato386 by Level 11
  • 6970 Views
  • 22 replies
  • 0 Helpful votes

I'm trying to write a regular expression to block files with the extension of .lnk, but I can't get the end of line anchor ($) to work.  So far I've come up with "\.[Ll][Nn][Kk]" and that blocks "test.lnk" but it also blocks "test.lnk.txt".  I tried ...

I have two FWSM's in an active active configuration. Both are currently on version 4.0(6). I would like to upgrade these one at a time. Is there any problem with upgrading one to 4.1(2) then waiting a week till I upgrade the second one. I always worr...

gm-douglas by Frequent Visitor
  • 772 Views
  • 1 replies
  • 0 Helpful votes

I am in the process of setting up our 5510 to replace our current SonicWall at my place of work.  When looking at our SonicWall config I noticed that the IP addresses we have setup for our phone vendor to access the PBX systems at our various sites a...

southpaw34 by Community Member
  • 974 Views
  • 3 replies
  • 0 Helpful votes

Resolved! IDS OS reimage

I read that all the configuration wiped out after doing the system reimage on IDS device. In those cases, shall we use the "Copy url current-config" (if I took backup before reimaging) or I need to configure manually again.And I understood that, "Cur...

gangadaran86 by Community Member
  • 1253 Views
  • 1 replies
  • 0 Helpful votes

Resolved! ASA 8.3 PAT

Hi All,I'm well aware that there must be several posts on this topic already (I've read a few) and even searched other articles, but I am having no joy whatsoever. Perhaps this will be a chance for someone to get 5 easy points.I'm currently running a...