Network Security

All,Does anyone know if CiscoWorks LMS will run on VMware?Thanks,Stephanie

Hello i have a problem, when i connect through ASA 5505 site to site (site 2 "DC2" to site 1 "DC1"), outlook 2007 (in DC2 ) can not run.and  I want both  routers know all users of both sites. ie routers must be authenticated users of the two  wholes ...

What does the '32' mean in asa images (i.e. asa804-32-k8.bin)?

Hello everyone, Thanks in advance for any help with this.Our company is in the midst of becoming PCI compliant and part of the PCI Standard document (specifically Section 6.6) requires us to configure the interfacing firewall to provide application f...

I'm runningNetwork Module IDS ona 3845 router.  The build is 6.0(5)E3.  Up until last week, Cisco has been putting out signatures for the E3.  The last one I've seen is the IPS-sig-S479-req-E3.pkg.  I've noticed that over the last week they issued IP...

Hello, I have a client that needs access to a particular server on the DMZ from the outside Interface - I have created a static PAT statement 1200 translated to 1200 (I have created the 1200 port so they can access this particular server) and created...

Hi,iam kalyan.Can you please tell me how to configure AIP-SSM-10 module in ASA 5510 on inline mode.1.what are the steps to be done in ASA and IPS (SSM module) for inline configuration.The ASA is in active/standby failover configuration.2.How the sign...

Hi guys:This is the firstime that I post something here, so here's my question:I got a problem with an IPS Module, because when I want to download something from the web (FTP, HTTP,etc) it's very slow, for example if I want to download something of 3...

Hi,I have a quick question regarding the auditing system in CSM. In Checkpoint, we can do an audit via SmartView Tracker to determine who was the last person did a change to the Checkpoint firewall. How about CSM? I believe CSM have something similar...

Hi there,PFA,We are facing an issue while accessing one of our Server in DMZ, which is connected to 2960 switch in DMZ from inside segment of ASA.We have two IPS boxes which are connected as per network diag attached.We are able to access that partic...

I am trying to limit the amount of typing by creating groups and adding an acl dependent on those groups, however i cannot get it to work. Attached you will see (hopefully) what I am trying to accomplish. I need to allow a few remote hosts to contact...

For Cisco Security Agent, is there a way I can tell what Shim's are enabled on an agent for a host? Is there a report? Some way from the Console I can tell wothout have to be on the host? Thanks!