Network Security

Hi Everyone, Please help me out to know this....which protocols comes under these planes.....?????a) Management plane b) Data plane c) Control planed) Service planeThanks,Kiran

Hi allI am gettings lots of errors on my firewall, saying portmap translation failed, but the thing is both ip addresses exist on the inside interface, so why is the firewall doing this?I have turned nat control off just in case.any ideas?Carl

Dear All,Anybody can help me with the number of accesslist supported by  ASA 5540. Its only for a tender document.Thanks in advance,Jaison

I have a client who want to run an ASA5550 transparently using contexts in multiple mode as below.  Context 1: ServiceIncoming trunk containing 81 and 82Output trunk containing 86 and 8781 -> 8682 -> 87 Context 2: ManagementIncoming trunk containing ...

I have an ASA-5520 running IOS 8-0-4(7).I have 24MB flash and 80MB DRAM.I want to install a 4-port GE SSM module and interconnect two (2) different Cisco 3750 switches as such:ASA-5520-1 -- g0/0 ------ c3750-A -- g1/0/1ASA-5520-1 -- g1/0 ------ c3750...

Hi, I have 5 usable static IP Address provided by my ISP.  I am using an ASA5505 with Security Plus firewall.  My question is, can I assign each usable IP Address to a specific VLAN so that when they go out to access the Internet, it will show that t...

Hi,i`m very new to pix and here my simple problem:i have created a VPNClient pool from the same range as the internal ip range. For example 10.0.0.0 /24 with client VPN pool of 10.0.0.150 - 180. For this i have created a translation rule:static (insi...

Dears;we have three sites and connected together via VPN IPsec Site-to-Site full mesh, now we install a new exchange and domain controller in every site.we have an issue between site 1 and site 3 but we dont have any issue between site 1 and 2, 2 and...

Hi halijenn / pkampana / allConsider a firewall is running as a Virtual firewall in a Multiple context mode .a) If now i want to introduce another firewall and configure active - active is it possible without any downtime considering that both firewa...

HiI'm looking at implementing an IPS for our Internet Edge networks and have been doing some reading up on the Cisco IPS and ASA ranges. I'm a bit confused about the capabilities of the various units and would appreciate some guidance. Our network in...

Are there any limitations regarding Dynamic Access Policies (DAP), i.e. CPU, Memory, walk through times?Use Case:ASA5520, 3000 IPSEC Users, LDAP Connection to ADThere are 200 Groups in the AD that will be referenced in the DAP.So there are 200 DAP En...

Hi ,I want to know how to save IPS 4260 logs.