Hi all,i have a setup with 2 X asa 5505. i configure both asa to a VPN site to site configuration - IPSEC (no split tunnel).my question is if i can enable multicast (pim sparse-mode) on that configuration and platform ?please advise,Avi.
Hi all,i have a setup with 2 X asa 5505. i configure both asa to a VPN site to site configuration - IPSEC (no split tunnel).my question is if i can enable multicast (pim sparse-mode) on that configuration and platform ?please advise,Avi.
Hello,I have a LAN IDSM in promiscusous mode wherre I'm seing too much of the below alerts, I've researched it and found out that it should be stopped! since it is a high severity alert!! however I guess summarization is preventing me from knowing th...
Planning on moving my standby fwsm to a new 6500 chassis; couldn't find any documentation on the procedure. The config should be stored on the fwsm (rather than the 6500 itself), so I'm assuming the move should be easy, just a matter of moving the "...
I ran into an issue after setting up a firewall with 8.3. Hosts on the inside that have static translations to public IPs configured within their object network configuration are being PATd instead of using the static nat translation. It's not unti...
Hi Guys,I have a simple setup and diagram is uploaded .Can i have a sample config anywhere on cisco.com website or any blog reference....In the diagram attached, i have 2 outside networks connecting to 2 DIFFERENT ISPs..... they are physically differ...
Hello,We're desinging a Network, for which I need some expert advise on.We need to build two tunnels from a Remote ASA, to a Hub ASA, and a VPN Concentrator (for redundancy). Basically, we're thinking of doing an L2L VPN between the two ASAs and a Re...
Ok....I'm feeling a little less intelligent everyday. So I am struggling trying to figure out why I'm unable to assign rules on my ASAthat will allow me to FTP from the DMZ side of my ASA to the Inside. Let me explain my situationASA 5520 Insi...
Good morning:I have cisco ASA 5520 and i am having high traffic per hour from my internal interface, For example can have 700 or 800 MB, this behavior come happening since 3 weeks ago.Can someone help me to know whats is happening?Thank in advance
Hello,Im seeing a Huge amount of events related with the signature ARP Reply-to-Broadcast 7102.The sensor saw an ARP Reply packet with its payload Destination MAC containing a broadcast address. This is not normal traffic and can indicate an ARP pois...
Currently I've been working on the configuration of several IOS Zone-based Firewall (over ISR2801 with IOS 12..4(15)T12) and I've read about the features and limits of the Self-zone for the router outbound and inbound traffic. I really prefer use the...
Hi all,I was wondering if someone could help me out with a issue I have. At present our corporation has all internet traffic routed via our HQ, through a Cisco ASA 5510 arrangement. I need to prevent client machines (subnet / range) going directly ...
I work at a small to medium sized business, where we have a Firewall (Cisco ASA 5510), an IPS System (Cisco IDM), and A Cisco MARS device. Is it neccessary to have all 3?Thanks
can any one tell me which ram is used in Cisco ASA is it a special RAM or normal DDR. if possible tell me the specification is ASA 5520 RAM
Cisco famously quotes max firewall throughput specs on all ASA models, but how do you tell if your firewall is reaching this maximum throughput? For example, there is a 300Mbps max throughput number on the asa 5510 in the spec sheet. How do I know if...
Hi,We are now using ASA 5520 firewall v8.3 ( migrated from PIX 515E) and everythink seems to work fine regarding the configuration syncho between the active and our standby asa device excepted that I'm always getting the following error when saving t...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
| Subject | Author | Posted |
|---|---|---|
| 05-05-2026 09:59 AM | ||
| 05-02-2026 06:09 AM | ||
| 04-30-2026 12:46 AM | ||
| 04-24-2026 07:04 AM | ||
| 04-22-2026 11:56 AM |
| User | Count |
|---|---|
| 9 | |
| 2 | |
| 2 | |
| 1 | |
| 1 |