Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
All,I wanted to load the factory defaults for my 881W so I could get a clean start. Following this Cisco article:http://www.cisco.com/en/US/products/sw/iosswrel/ps5187/products_tech_note09186a00802017a1.shtmlI used the following commands while telnet...
All,I have an integrated 881W with a built in 801 access point. I'm interested in increasing the range of my AP. I'm interested in considering any configuration changes while still maintaining support for N. I've included a copy of my running conf...
I have two basic problems and could use help1.) My neighbors are using the same wireless channels as I am (6 + 10). I would imagine that I should change my channels to avoid contention/congestion. My wireless networks (SSIDs Fran...
All,I have a wireless client (MAC Address: c43d.c7a9.4917) that is connecting to my wireless VLAN at a slower linkrate (56Mbps) than is desired. Thewireless client is 802.11n version 2.0 capable, which means that it is capable at connecting at a hi...
All,I need to update my Cisco 881W config to allow port forwarding FROM the Internet TO the following inside device as follows:IP Address: 192.168.1.254Protocol: TCP/UDPPort: 5001This device is a Slingbox Pro-HD and I want to be able to view it fro...
Let me provide more information. Imagine that my house is a rectangle and that my existing 881W is located in the center. I am unlikely to move the 881W as it will remain in the center. I am envisioning installing WiFi security cameras in each of ...
Thanks Scott and leolaohoo.My 881W is already located dead center of my small house (2100 square feet under air) as I moved it there recently to get it out of my bedroom closet. Since I'm unlikely to move it, would I be better served disabling the b...
Do I use these two new lines in replacement of OR in addition to the last "zone-pair" config line?zone-pair security ccp-zp-out-in source outside destination inside service-policy type inspect ccp-slingbox-access-inPlease clarify. Thanks.James
OK. It looks like we are down to one error message now. Here is the last one:Pinecrest-rtr#config tEnter configuration commands, one per line. End with CNTL/Z.Pinecrest-rtr(config)#$static tcp 192.168.1.254 5001 interface Dialer0 5001Pinecrest-rt...
