Network Security

I will explain scenario in 2 steps :1. Current Setup :We have T1 line coming from datacenter to our office connected to serial port of 2621 router. Fastethernet0/0(FE0)  is connected to 2900 Catalyst switch.Firewall Pix 515E (OS version 8.0) is also ...

Hi Guys ,Anybody knew the oid for Processing Load Percentage from module ASA-SSM-10 ? Because i want generate graphs in Cacti box .ThanksJorge Ferreira

Hi All.   Any separate license is required to upgrading os from 6.2(1)e3 to  7.0(2)E3 .Pls find the show version of IPS.sh versionApplication Partition:Cisco Intrusion Prevention System, Version 6.2(1)E3Host:    Realm Keys            key1.0Signature ...

I can't download PSIRT XML data for my RME 4.2. I have tried to do it from RME and manually. My CCO account is valid and I have partner privileges but I cant get it to download no matter what I have tried. This is the link I am using to manually down...

Hi, I am trying to bypass one device from H323 inspection.  I created an ACL to deny IP any to the devices IP internally and externally, then permit ip any any. Then I created a class-map that matches the ACL, applied the Class-map to the service pol...

Hi!Please, I need to know how can I configure the availability for all my switches and routers that manage with CiscoWorks.I mean I need a report of uptime (uninterrupted time of operation).Thanks very much!best regards

Hi All, Can anyone help me in solving the following SNMP issue,     I tried to get the SNMP contexts configured in the device through vacmContextName OID from SNMP-VACM-MIB, but the device responded nothing for the same. But the CLI command 'sh snmp ...

I have 3 devices in Security manager 3.1.1 that still show up in the list of devices in the Deploy Saved Changes dialogue box even though I have used the Discard changes menu option, I have unchecked the Manage in Cisco Security Manager in the Device...

This is more of an announance than anything. Here is the question/problem. If I sign into my computer as me, and launch the ASDM launcher, I get a .asdm folder  (which has the log information) put on my desktop. If I sign into my computer as say the ...

Good Afternoon folks,In attached, are my network diagram and my "show run" , and my problem isMy server (172.16.3.1) cant ping or access the other server (172.16.4.1). What is wrong??Before I put the nat rule (nat (inside) 1 172.16.4.0 255.255.255.0)...

I have the switch set up for mac notification, and the switch has the below config. But no mac notification traps get sent to the CAM.interface GigabitEthernet1/0/24 switchport access vlan 800 switchport mode access snmp trap mac-notification added s...

We have a 5520, with the CSC, though without the Plus license.We would like to block Facebook chat, without blocking the rest of Facebook.A bunch of searching has turned up the following 3 URLs to block, so I put them into the CSC under URL Blocking....

Hi, I am currently facing the following issue with FWSM module installed Cisco 6509 E Chassis, Please go through the following questions in details and please let me know what could have been the issue with this case. we have go two FWSMs and both of...

HiI have a head office (cisco 877) with 2 remotes sites (also 877's) that VPN'd into head office.All was well, and I was able to ping from Remote site 1 to Remote site 2 via the head office router. Not the most efficient but at least it worked.I adde...