Network Security

Hello,I'm trying to allow traffic between 2 VLAN's/sub interfaces on my ASA, the both have their security Level set at 25.  At the moment I can't even ping devices between the 2 and my access lists are wide open.  I raised one of the security groups ...

Capacity planning for interchassis links is an important part of VSS deployment. Include capacity for FWSM failover pairs to account for failover/state VLAN links between the two chassis if FWSM interchassis failover is deployed. It is recommended to...

Hi All,I have a cisco asa 5520 with a cisco 3750 Switch.   Few VLANs as I have many public ip address and private ip address 192.168.1.x.ACL is any any permit on all the interface.I applied interface NAT (PAT)  from private vlan to outside and public...

Hi there,I have 1 CAS and 1 CAM. Everything works fine if I use localDB authentication.I tried to complete SSO AD configuration, from CAM installation guide. SSO service started to work successful. I'm trying to login to the domain - It's ok, I see g...

I have an issue with the fact that my PIX is nat'ing my network correctly.  However, every so often I get an issue where the network we are accessing via the NAT'ed addresses stops responding.  We use alot of web based apps so we will recieve a page ...

The problem is to scan a network Ip range from an anonymous host and determine what type of devices residing on that network. Here are some device criteria:1) May be Cisco, 3com, HP, etc. Device manufacturer is unknown2) Device might be firewall, swi...

hi all,How can we check particular S2S VPN tunnel is up from how much time (what is the up time of S2S VPN tunnel) in ASA firewall.thanx in advancergrds,Naveen

Hi all,Looking for some assistance with creating an ACL to allow traffic both ways for a device.  We have an ASA 5505 for our VPN, however there is a device on our network that needs to be monitored from the vendor.  I have an open IP from the ISP th...

Hi All,Is there any method to configure scheduler backup in FWSM.Thanks & RegardsGanesh.H

Anyone know how to retrieve the arp table of the ASA appliance via SNMP?  For example, the command "show arp" provides the MAC/IP address of devices directly connected to the ASA.  How can I retrieve this information via SNMP?  I know how to do that ...

eg: plink -ssh -m commands.txt somebody@pix.somewhere.com -pw xxxwhere commands.txt is:enablexxxshow versionlogoutwhich works fine but, is there a way to use something like:plink -ssh somebody@pix.somewhere.com -pw xxx enable^nxxx^nshow version^nlogo...

Hi,As per one of the documents in Cisco, it is recommended that to share the traffic/links in both slots of ASA.Is there any recommendation or standard for traffic volume what each Bus in ASA 5550 can handle.When looking at the traffic stats in our A...