Network Security

Engage with peers and experts on network security topics such as FTD, FMC, FDM, CDO and ASA.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Hi,We are looking to move our FWSM (Pri & Sec) which are installed in a pair of 6500, to another pair of 6500's. My plan is to migrate the HSRP standby vlan's as well as the secondary backup FWSM to one of the new 6500's, then once that is complete,...

I've upgraded from 7.0.(4)4 to 8.0.4(4) with intermediary upgrade of 7.2.4 however both upgrades were done in monitor mode before a reload. If 8.0.4(4) is running fine in RAM will it be OK to copy this image to flash, set boot system file and save c...

sgantt by Level 1
  • 464 Views
  • 2 replies
  • 0 Helpful votes

I am getting ready to upgrade from v6.1 to v7.0. I noticed in my IPS Active Update Bulletin e-mails that signatures for are platform 5.x and 6.x. What about v7? Should I assume the signatures for v6 are the same for v7?

rmeans by Level 3
  • 477 Views
  • 2 replies
  • 0 Helpful votes

Received follow error after service module was restarted:From diagnostics event - 07/13 13:08:10.573 E [2] komodo_plus_lb_pc_port[2/7]: check_ether_packet failed (err-code 43)From sh log -Jul 13 13:04:34: SP: The PC in slot 2 is shutting down. Pl...

mkelly26 by Level 1
  • 1156 Views
  • 3 replies
  • 0 Helpful votes

I have 2 5540 ASA in an Active / Standy setup. The Active firewall has a packet shaper sitting between it and the inside LAN. When I reboot the Packet shaper the FWs failover. I have the default timeings for failover 1 second hello 15 seconds keepali...

ricey by Level 1
  • 794 Views
  • 4 replies
  • 0 Helpful votes

I need to configure the following rule and need help to configure a ACL:Server (192.168.254.22)is in the DMZFrom server Port 1521 open only to users inside the xyz domain (not externalusers)From Server Port 80 open to any host (internal and external)...

I have an issue occuring that I've not saw before.I have a Global NAT configured. I have a single host that continues to display with 2 translation (both the same). the translation is correct, but I cannot communicate with the box. what happens is...

hiI'm reviewing the situation next three traffic zones outside, inside, DMZ,service-policy xxxx-policy interface outsideservice-policy xxxx-policy interface insideservice-policy xxxx-policy interface dmz_stgoand I need to lower the level of examinati...

I have an IPS-4215 that I am putting online for the first time. I am upgrading the signature file. My question is this: what else do I need to download to monitor this device once it is running?

Review Cisco Networking for a $25 gift card