Network Security

hello,in my connection Remote VPN there requred route or we directly give connection from ASA 5540. is it possible.

Prudent config I have on there:logging enablelogging mail errorslogging from-address x@y.comlogging recipient-address a@b.com level errorssmtp-server 10.1.1.1So far no emails are getting to me. I've run 'debug smtp-client' and all I get is "lookup_an...

Hi All,If a single ASA 5510 (4 ports) connects to 3 different 857 ISR routers. On each port of the ASA 5510 (outside1, outside2 & outside3) the WAN IPs are of different subnets. The 857 routers only provide the ADSL connection and nothing else.The 4t...

How do I configure a standbyIP address, from a Context Firewall.

Today I open the IDM and I saw that the Analysis Engine Status was "Reconfiguring the Engine".and CPU1 was 100%. is this normal? When this message it's appear?

Hi All, Is it possible to connect two ASA in HA over a layer 3 link (Different subnets)thx,

Hello, I'm trying to set up an Easy VPN on a cisco 871 router. We are doing it in extended network mode, and the VPN connects fine. But I need to know what more I need. In theory, when you connect to an ezvpn extended network mode you get an IP of th...

I want my ASA 5540 having OS 7.x to log only telnet and console login informations to my external kiwi syslog softwareI have typed logging host inside 10.1.1.1and then I have set the logging trap to informational I only want line vty and console logi...

I have two ASA-5520's in active/standby mode servicing a 500-node LAN w/ 1 outside interface, 1 inside interface, and 1 DMZ. How best to implement IPS, preferably using integrated modules, and without introducing a single point of failure? Also, what...

Hi,I have one client who have an ASA 5510 device for Remote Access and siteto-site vpn. Site-to-Site VPN work properly, but i have problems with Remote Access sessions. The device configured by the previous system administrator and to tell you honest...

I have a Linksys router and replaced with a pix unit. Since I replaced it I have some problem with emails through outlook. We use Mdaemon for emails and it is configured on the server 10.1.1.10. Here is what I observed with emails and the problem is1...

Hi,I think this might a be policy NAT required, but I have never tried this before.On our LAN we have a subnet 192.168.100.x/24 and this need to get to an IP range of 10.100.0.32/27 which is a remote company network, tyhe thing is they also have a ne...

Hi, Is there a way to see the number of TCP Connections/Sessions on AIP-SSM at any point of time. Regards.