Network Security

Hi,I had configured a CAM 4.5 with CAS 3310.After authenticated successfully through Web agent, the page redirected to authenticate session again. Is there any option need I to change? Thank you.

Hi,Understand that AIP-SSM doesn't support email alert, may i know what are the alert option that I can configure in order to receive notification when a severity 1 event had been detected?regards

Hello,I have 4 security zones defined on my 2611XM - 12.4.15T8 router. The customer defined its security policy as a destination policy to all 4 zones, egfrom 10 hosts/networks to zone1from 20 hosts/networks to zone2, etc,where the hosts/networks are...

Im using a RVS4000 SOHO 4 port Giga_ethernet router.I'm trying to set the firewall to work with different policies. But this seems impossible.There are normally 10 policies available.What I try to do is give two PCs different access to teh web at dif...

Hello, Customers having IPS 4215 version 6.0(5)E3 are having their sensor crashing following auto update from an FTP server.The web interface is no more accessible and the analysis engine stopped( I've attached the show tech-support)The problem happe...

I wonder if anyone can help me please. I am setting up vpn tunnels between my site and 3 other sites (there is no connectivity required between these 3 sites).I am using a Cisco 7301 as my endpoint and have a single IP address that all three sites ha...

How I can configure IDSM2 in Inline mode in a Router 7600

I've been logging what is very obviously an attack directed at some of my dns servers. My router/IDS has logged hundreds of thousands of these requests in the last 7 days. The router is reporting the following events in my syslog which is what initia...

I have CAM and CAS failover bundle. 2 CAM and 2 CAS. I am purchasing a third-party Trusted CA. How many certificates will I need to purchase? Do I need 1 cert for all the servers, 1 per F/O bundle, or 1 cert per server?And can I use a private IP to g...

Running ASA v8.x. I'm trying to save the run to a TFTP server that's connected via a VPN tunnel. I have "management-interface inside" set up so I can get remote access via ASDM, but I'm not sure how to get TFTP to work. I defined the tftp client in c...

Hi I'm having trouble trying allowing specific access i.e smpt, http from clients in vlan 1 to servers in vlan 2.* Both Vlan's access the internet with Dynamic NAT. * Both Vlan's currently use the same security level* nat-control is enabled with "sam...

Hi,I'm taking over admin of an active/standby pair of ASAs running 7.2(3) with two contexts running in transparent mode.Apparently there is no admin context configured on there. I need to remotely access system execution space so will need the admin ...

I am beginning to run out of address spaces and I am looking at getting another range. I would like to create sub-interfaces but I am running into one problem. When I move the interface "outside" interface to one of the subinterfaces anything applied...