Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey Everyone,I just got a new 5510 and need to get a polycom head unit to NAT through and it doesn't want to seem to play nice. (At least that is what I think it is) I have set up a static nat for the unit itself and set up an outbound and an inbound...
Hey all,I want to setup ssh to access CLI on the switch from my workstation. The current IOS on the switch is c2950-i6q4l2-mz.121-22.EA2.bin which is not the 3des crpyto image from what I understand. Do I need the 3des crpyto image before I can use S...
Hey all,I have a couple of general vlan questions that I was hoping to get some help on. Currently I have 2 vlans on a campus with six buildings. I also use VACL's on the academic vlan(3) to prevent/allow to certain servers on certain ports on vlan1....
Hey all,I am in a bit of a quandry. I have recently got a 1841 security bundle with a T1 wic.I have been trying to set this up a certain way and I don't think that I can do it. Here is a little background info.I have a Point to Point Frame Relay T1 c...
Hey all,I want to setup a small VoIP solution in my house and I have the slightest idea where to start. I am thinking of Using Vonage as the provider. What sort of equipment would I need on my end to make it happen.I was looking at an 1801 router so ...
Thanks for the reply. I think it is but it has been about 2 years since I got the first 4506. I think it has a sup3 and the other building has a newer 4506 that has a sup4.How do I figure that out. Below is a sh ver from the older 4506 and it states ...
Thanks for the reply, This now brings up another question. Right now, I have a 4006 as my core L3 switch and it is doing all of the routing. In two of my buildings, they have 4506's doing most of the L2 switching. Can I remove some of the burden of t...
Thanks for the reply,It is two fold why I want to try this, one is a learning experience and two, geek factor. I have read that an 1800 series router can handle the embedded versions of CME and Unity. I think this is cisco's solution for remote/bran...
