Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
Is it at all possible to have two or more NAT translations to external IP addresses that translate to a single internal IP address on an ASA 5510? For example can 1.1.1.1 and 1.1.10.1 translate to the same internal IP address.
Hi, after the CSA 6.0.0.220 upgrade I have some old kits to delete and some new kits to create for the actual groups.I'd like to know all the post-upgrade operations necessarythanks in advance
Hi,After the port taken into control under the profile & bounced it shoud change the vlan to the authentication vlan which is not happening. I have configured everythng as per best of my knoldge.Can anyone pls guide me if anywhere I am missing someth...
Hey,i have a little prob in my test-lab.The Lab: pc -> switch1 -> asa -> switch2 -> access pointI configured the devices and after they booted, i can ping all devices from the Pc ( AP, FW, Switch2 behind the asa )After about 20 Pings i get ping time...
HiI have received 7 ASA (1*5510 and 6*5505) with the PAK associated for security plus licenses.I connected to the cisco web site to generate the activation keys.I received 5 activation keys by email but 2 are still missing and now I cannot use the PA...
Here is the deal. We dug up an old Cisco PIX 501 that has been previously activated and used sometime way back when. I looked through the config and noticed a lot of commands that vary from what I've learned on the CCNA track. I saved the old conf...
Hi guys,what is the difference between static nat & alias?is it that in alias ip addresses can be in any interface?just i cant no understand when to use alias command? and why?Regards,
Is there a way I can allow connection from inside the firewall to one of my public IP which has a static NAT?I connect out from internal and want to connect via port 80 external on a second IP mapped back to an internal address? Is it just a case th...
Hi guys,I've 2 core switches with 1 FW Module in each switch..i want to make a failover configuration between the two FWSM [Active/Passive], so if one goes down other will work..there is any config guide or document i can follow?or kindly let me know...
I have a network where I use two separate ISP connections on different locations within the same building. I would like to install an ASA 5520 to each connection as we don't have any firewall at the moment. Some of my traffic from one segment to the ...
Dear all,I am facing strange problem with 6500 IDS module.Management port of IDSM is up and Data port 2 Operational Mode: down.When i check traffic on this port it is one way only.I can able to ping IDSM management IP but when i try to telnet it give...
Hi,I have two 6509 each with FWSM module. we will configure this in active/standby. We want to configure 10 vlans for inside and 5 vlan for outside will connect to my mpls. internet gateway cloud. I don't want any restriction between my inside vlans...
I wonder if anyone can tell me the best way to configure ISP redundancy like can be done in checkpoint, not to confuse with device redundancy Many Thanks Mark
