Hi Expert,We have Nexus 4000 that is constantly having CPU spikes and shows 100% on CPU States - UsersSYD-ES-L06-SA01# sh system resources Load average: 1 minute: 0.11 5 minutes: 0.11 15 minutes: 0.09Processes : 211 total...
Hello Friends,I have a very basic setup here but strange the router is learning RIP routes advertised by the switch but the switch is learning anyRIP routes. Debug shows the switch is sending updates but not receiving any. There is also t...
Hi Experts,I have a situation here where after migrating from PIX 6.3 to ASA 8.4, VPN connection from window server 2003 and 2008 fail to connect. Strangely, win7 or win 8 works perfectly well.It failed due to reason=DEL_REASON-IKE...
Hi There,We have a Cisco ASA:QCU-HQ-FW1# sh verCisco Adaptive Security Appliance Software Version 8.2(4)1 Device Manager Version 6.4(1)Compiled on Fri 17-Dec-10 17:02 by buildersSystem image file is "disk0:/asa824-1-k8.bin"Config file at boot was "st...
Hi, We are currently graphing SIP call statistics via SNMP OIDs below1.3.6.1.4.1.9.9.63.1.3.8.5.1.1.2 – Active calls in1.3.6.1.4.1.9.9.63.1.3.8.5.1.2.2 – Active calls outCan you please advise the correct OIDs for Active calls in/out ...
The ezyvpn server firewall is not managed by us but I have ask if we could collect the debugs when we try installing the ASA again. Currently we have reverted to PIX and it works ok.Kumar RamalingamSenior Network EngineerLogicalis Australia Pty Ltdt ...
Thanks, so if i want to retain the IP, then i need to configure as network-extension?Router(config-crypto-ezvpn)#mode ? client Client network-extension Network Extension network-plus Request a IP address identifier in NEMWhat ar...
tunnel-group DefaultRAGroup type remote-accesstunnel-group DefaultRAGroup general-attributes no address-pool no ipv6-address-pool authentication-server-group LOCAL secondary-authentication-server-group none no accounting-server-group default-group-po...