Network Security

Hi Folks,We have a multi-context ASA setup on our network. Without going into too much detail, one of the contexts is used specifically for primary / secondary school access.We have recently migrated all our schools to a new IP address scheme. Howe...

My company has a client that requires us to have a site to site VPN. They are requireing us to NAT our subnets to another private address or private subnet.My question is how to accomplish this on an ASA 5510 using the ASDM. We should be able to inti...

Hi,I am running version 7.0(7) on a PIX 515e. My question is I am seeing many dropped VLAN untagged packets. See output:Interface Ethernet0 "outside", is up, line protocol is up Hardware is i82559, BW 100 Mbps Full-Duplex(Full-duplex), 100 ...

We are running LMS 2.5.1 and have not updated the Device types in a while, waiting to purchase LMS3.In the meantime, catalyst 4500E are being added to the network and they are not being archived by LMS 2.5.1 because the Device type is "unknown".Could...

Dear All,We will use CAS 1 for Local users (wired/wireless) as L2 OOB virtual GW.We will use CAS 2 for VPN users as L3 In-band virtual GW with VPN router.Now we have one remote site connecting to our ASA DMZ and other remote sites connecting to our W...

Dear allI am adding a new jump station to the network which is supposed to connect via ssh only to ASA.using ASDM, I add teh host address of jumpstation under properties, device access, secure shell and apply. easy enough, but does not work...any sug...

Hi,I am using PIX 7.0 and i have created a IPSEC Vpn and trying to connect the same from my VPN client 4.0 The group authentication is working fine but after for the user authorization is asking for username and password Since we are not using any TA...

Hi there,Cisco states that a failover config need the same hardware for both nodes. I have two 515's. RAM, SW version, interfaces and licences are no problem, but processor types are different. Does anyone have experience with such a config when set ...

HiI have installed a NAC module in to one of our router and configured it according the configuration document. I now want to brows to the server but i am getting a message on the login page stating "Login page is not configured, please report to adm...

Hello,It's a first time for me on ASA 5510 and I need to know to configure a DMZ on ASA 5510?Regards

Hi GuysI have CSM Version 3.1 , I am unable to import VPN Configuration to CSM from ASA.Regards/Asfar

hi my name jae hwa lee from south koreaI need help from many experts when configuring fwsm, i can't append log to acl any morein case of no acl log option, acl is normaly configured and compiled but when applying acl log, acl is not applied and error...