Network Security

Hi,We have installed ASA 5505 in Datacenter and configured two zones DMZ and Inside. The App Servers are placed in DMZ and DB Servers are placed in Inside Zone. One unmanagable switch is connected with DMZ interface of FW and the second one with Insi...

One general question-When we access internet using broadband connection from home will it be a kind of IPsec tunnel from my PC to Service Provider network--Why I am asking is because when I connect to Service Provider network i will get an IP address...

Hi All,I have configured the ip address in the IPS 4240,Like x.x.x.201/24,x.x.x.1,When i type the https://x.x.x.201 in the internet explore ,page is not opening.What would be the problem and give the ideaThanks.

Hi Team,I have following question about Nating:-1. static(inside,outside)-Will this command works bidirectionally i.e. Traffic which is coming from outside to inside or reverse both will get NATed OR it only mean that the traffic which is coming from...

Hi Team,As We know that their are 6 steps in Main mode and 3 Steps in Aggressive mode for IKE SA.In Main Mode the steps are:-In Steps 1 & 2 the Initiating peer will send the required Encryption algorithms,Hash algorithm etc over internet to the peer ...

What is the use of service internal command? How to use it?

Hi,does anyone know if the ASA5505 supports 6in4/proto41? I know it doesn't support terminating anything other then an IPSec connection, so it seems like my only option would be to go with a provider called sixxs which does have an option that suppor...

i am unable to create sub-inerface on my asa 5540.Failover is active/stand-by.How can i create sunb-interface and vlan in ASA 5540.

Hi all I have 1 central site and 3 remotes sites connected by wireless link. Call Manager is installed on the router 3825 and already running. I need to configure and secure traffic between the central site and the 3 remotes sites and install ASA 552...

I am looking for an option to allow me using 'ANY' keyword for destination port on the extended access-list. With and without object-group, I don't see any such option on ASA. I can only see port-object range 0-65535 that can be used for this purpose...

cisco asa5505 how to upgrade

I use VPN Client 5.0.04.0300 to connect to a remote VPN network (ASA 5100) firewall. I can successfully login but I cannot access any resources (not even ping servers). Other collegues can do this from home and can even do RDP. I tried this both from...