Network Security

I have a Cisco PIX 506e which I would like to log all outbound SMTP traffic down to internal IP address. I have a rogue spammer on my network which I would like to track down. I am not to familar with the CLI and prefer to work with the PDM if possib...

Hi,I have installed a CSA MC with they agents, but I can't distribute the black or white list to diferent groups, when I created a Black/white list, this are generate in all the groups but I need that this list will be distributed in diferent groups ...

Hi All,I have a scenario wherein SIP sessions need to be established across FWSM. The following is the scenario:-On the FWSM there is a DMZ on which all voice devices reside which includes cal manager, voice routers and ip phones.The voice routers ar...

Hi,We configured FWSM in multicontext but without NAT/PAT under each context, we have added static routes on the MSFC for reachability of intside vlan under each context but somehow we can't ping from outside LAN to inside context/zone lans.We have c...

Hi Team,One small query--I have read somewhere that Routers are packet Filtering Firewalls(which can process the traffic at Layer-3 and Layer-4)but when we configure access-lists in routers ,then we can even mention the upper layer protocols(http,ftp...

I am attempting to access our ASA via ADSM. We are using ASA 8.0.4 and ADSM 6.1.3. When I web in using my https://<ip_address> and login, I receive a pop up window that says "ASDM cannot be loaded. Click OK to exit ASDM. Unconnected Sockets not ...

This is an exersize in learning, and I'm getting stuck on the OSPF/Routing piece.What I am wanting to do is build a Lan-to-Lan VPN network between a 2811 and a 3005. Once that is done, inner routers at each site will run OSPF and should populate rou...

I have a vendor who uses an ASA at his end to build VPN tunnel to us. He gets the following error when he attempts to send traffic to us through the VPN tunnel. One thing to point out is that I am able to see his syn packet come to the destination ...

Here is the config that I believe allows ASDM accesshttp server enablehttp 172.30.0.0 255.255.0.0 insidehttp 172.20.0.0 255.255.0.0 insidehttp 192.168.1.0 255.255.255.0 managementOur vpn dhcp pool is 172.30.0.xOur internal network is 192.168.133.xso ...

I wounder if there is any easy way one could monitor the bandwith on the external interface in regards to what ip is using what amount.This is for tracking who is using up the bandwith at a small ISP link when the link fills up.yes I know of fireplot...

Can I configure 'event action filters' from the CLI or do I have to use SDM?